LG Electronics owner manual Optional Extras Only 26/32/37/42/47LT640E, AN-WF100

Page 6

ENGLISH

6ASSEMBLING AND PREPARING

Optional Extras (Only 26/32/37/42/47LT640E)

Optional extras can be changed or modified for quality improvement without any notification. Contact your dealer to buy these items.

These devices only work with certain models.

AN-WF100

Wireless LAN for Broadband/

DLNA Adaptor

NOTE

yyAntenna Isolator Installation Guide

-- Use this to install TV in a place where there is a voltage difference between TV Set and GND of antenna signal.

»» If there is a voltage difference between TV Set and GND of antenna signal, the antenna contact might be heated and excessive heat might cause an accident.

-- You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. It is recommended to mount the isolator to the wall. If it cannot be mounted to the wall, mount it on the TV. Avoid disconnecting the antenna Isolator after installation.

-- Before starting, be sure that the TV antenna is connected.

1. Connect to TV.

Wall

 

ANTENNA/

 

CABLE IN

or

 

Cable / Antenna

 

 

 

 

 

 

Isolator

 

2. Connect to Set-Top box.

Connect one end of the isolator to cable/antenna jack and the other to TV set or set-top box.

“Equipment connected to the protective earthing of the building installation through the mains connection or through other equipment with a connection to protective earthing - and to a cable distribution system using coaxial cable, may in some circumstances create a fire hazard. Connection to a cable distribution system has therefore to be provided through a device providing electrical isolation below a certain frequency range (galvanic isolator, see EN 60728-11)”

When applying the RF Isolator, a slight loss of signal sensitivity can occur.

Page 5 Page 7
Image 6
Page 5 Page 7
Contents LED LCD TV Table of Contents Licenses Open Source Software NoticeAssembling and Preparing UnpackingEA, M4 x Only 32/37/42/47LT64 See p.11 Depending on model See p.14EA, M4 x Only 26LT64** See p.9 Only 32/37/42/47LT64 See p.14Optional Extras Only 26/32/37/42/47LT640E AN-WF100Screen Remote control sensor Power Indicator Parts and buttonsOption -menu Speakers Clock LED Lifting and moving the TV Setting up the TV Attaching the standM4 x Mounting on a table Image shown may differ from your TVMounting on a wall Your local dealerWall, it may fall and result in severe injury Use an authorized LG wall mount bracketTidying cables Making Connections Adapter connectionAntenna connection Hdmi connection DVI to Hdmi connectionComponent connection RGB-PC connection Composit connection Audio connectionDigital optical audio connection USB connection Speaker output SetupHeadphone connection Cable SpecRemote Control PowerCleaning your TV MaintenanceTroubleshooting Power cordOnly 26/32/37/42/47LT640E Specifications ModelsDigital TV Analogue TV New Zealand Television System DVB-TSignal Component HDMI/DVI-DTV supported modeHorizontal Vertical Resolution Frequency KHz RGB-PC, HDMI/DVI-PC supported mode Horizontal VerticalYyThis feature is not available for all models IR CodesRS-232C Configurations External Control Device SetupRS-232C Setup Type of connector Sub 9-Pin MaleCommand reference list Communication ParametersCarriage Return Transmission / Receiving ProtocolTransmission/receiving protocol Ascii code ‘0x0D’Screen Mute Command k d Power Command k aAspect Ratio Command k c Main Picture Size Volume Mute Command k eOSD Select Command k l Tint Command k jSharpness Command k k Remote control lock mode Command k mTune Command Command m a Energy Saving Command j qAuto ConfigureCommand j u Programme Add/SkipCommand m bInput select Command x b Main Picture Input Real data mappingModel Serial No
Top Page Image Contents