ADJUSTMENT INSTRUCTION
1. Application Range
This spec. sheet is applied to all of the LD61A chassis manufactured at LG TV Plant all over the world.
2.Specification.
2.1Because this is not a hot chassis, it is not necessary to use an isolation transformer.
However, the use of isolation transformer will help to protect test instruments
2.2Adjustment must be done in the correct sequence.
2.3The adjustment must be performed at 25±5°C temperature and 65±10% relative humidity if there is no specified designation.
2.4The input voltage of the receiver must be kept between 100~220V, 50/60Hz.
2.5Before adjustment, execute
3.Channel Memory
3.1Setting up the LGIDS
1)Install the LGIDS
2)After installation, restart your PC.
3)Extract [files.zip] to folder [c:\LGIDS\files]
4)Start LGIDS.
3.2 Channel memory method
1)Press TILT key in Adjust remocon(Automatic setting).
2)Setting up like bottom figure
(Confirmation: Press ADJ Key in the Adjust remocon. Select "System Control" by using ▲/▼ 
(ENTER))
6)Select proper CH_memory file(*.nvm) for each model at [Channel Download] => [Write Batch].
Next, select proper binary file(*.bin) including the CH information for each model at
[Channel Download] => [NVRAM File].
7) Click the [Download] button.
It means the completion of the CH memory download if all items show 'OK' and Status is changed by 'PASS' at the lower right corner of the window
4. Hudson Download
3)Connect RS232 cable .(Use the general
4)Operate LGIDS
5)Select "Hurricane" and "ALL" on Model dialog and check your connection in Communication dialog.
(If your connection is ‘NG’, then set your PORT(COM1,2,3,…) correctly. If your connection has completed, you can see
Ready )
4.1 Hudson Download method
1)Press TILT key in Adjust remocon(Automatic setting).
2)Setting up like bottom figure
(Confirmation: Press ADJ Key in the Adjust remocon.
Select "System Control" by using ▲/▼
press (ENTER))
- 13 -