PREPARING FOR USE
Installing the batteries
Use your Personal® music center III with the LIFESTYLE® system after installing the supplied batteries, as follows:
1.Slide the cover off the back of the Personal® music center III battery compartment.
2.Install the four AA (IEC LR6) batteries, matching the polarity markings (+ and
3.Slide the battery cover back into place.
+
+
+
+
Note: Change the batteries when you notice a marked decrease in the range or response of the remote.
Getting the remote ready
Your Personal® music center III is set at the factory for use in an expansion room, while the LIFESTYLE® system control console and primary remote are set for use in the main room. The use of unique room codes lets your LIFESTYLE® system know where commands it receives originate, so it can respond in the appropriate room.
•Your Personal® music center III remote and expansion product must both be set to the same room code. Your Personal® music center III remote is initially set to room code B. If the expansion product is also set to room B, you do not need to do anything.
•To view or change the remote control room code, see “When to change the room code” on page 24. To change the room code in the expansion product, see the owner’s guide that came with it.
The signals from a remote in one house can possibly reach and affect the operation of a LIFESTYLE® system in another. Changing the house code for the system and all the remotes used with it avoids any conflict.
•The house code in the Personal® music center III remote must be the same as in your LIFESTYLE® V25/V35, 235, or 135 home entertainment system.
•Both products are initially set to house code 15 and should work together unless the
house code in your main system was changed. To change the house code on the Personal® music center III, see “House Codes” on page 24.
Note: For more information on changing the house code, see the operating guide for your LIFESTYLE® system.
If the room code and house code are correct, you can begin to use your remote now.