Standby Mode

18 Series LCD TV

In Clear All mode, press【OK】/【V+】to unlock all of the programs.

Note: In child lock menu operation, each function cannot be activated until the correct password is entered. If the password is forgotten, the default password of “1601” is still valid.

Using the PC Setting menu (for PC mode only)

1)Press【MENU】and then use【V+】/【V-】to select the PC Setting menu.

2)Press【P+】/【P-】to select the desired field.

●Auto Tracking

To adjust automatically the picture’s clock、phase 、H Position and V Position to get the best visual effect

●Phase

To adjust pictures’ sampling phase in PC mode

●Clock

To adjust pictures’ sampling frequency .

●H Position

To adjust picture’s position horizontally in PC mode.

●V Position

To adjust picture’s position vertically in PC mode. Note:

In the menu, gray items means invalid to operate in the current mode.

OTHER FUNCTIONS INTRODUCTION

Press the 【】 on the TV panel/Remote Control, the LCD TV will store the current setup and enter into the standby mode with a red indicator light. To Power on the LCD TV, press the button again.

Signal Switch

Press【TV/AV】on the remote control to select the signal sources orderly. They are TV, AV1, AV2, YPbPr, PC, and DVI.

The upper-right corner of the screen will display the corresponding information.

Channel Selection

Press【CH+】/【CH-】on the panel or【P+】/【P-】on the remote control to increase/decrease the channel number. If a channel number is in SKIP ON mode, the next channel will display orderly.

Three numbers can be input at most, if you use the number button on the remote control.

PAGE 17