Installation

1.Remove the LCD TV from the box and place it on a flat surface in a well-ventilated location.

2.Connect the output terminal of RF cable to the corresponding TV RF signal input terminal. The LCD TV is a high-tech digital product. Do use quality RF cable to obtain optimal results.

3.Connect the output terminal of the AV devices such as YPbPr, DVD to the corresponding terminal of the LCD TV.

4.Connect one end of the VGA terminal to the corresponding signal source terminal, and connect the other end to the corresponding LCD TV terminal. Screw down the screws on both sides to secure it.

5.Ensure that every AV signal cord is correctly connected to the corresponding interface.

6.Connect one end of the AC power cord to the AC input jack of the LCD TV, then plug the other end to the corresponding jack.

7.The panel can be tilted upwards by no more than 100 to achieve better visual angle. When doing so, so rotate the TV with two hands, one to fix the pedestal while the other to tilt the panel. Take great care and do this in a moderate pressure in case any accidents happen.

General Operation

Switching the TV On

1. In Standby mode, press【】on the remote control or front panel to enter to Power On

mode.

2 The indicator is red when the TV is in Standby mode.

Switching the TV Off

1.Press【POWER】on the remote control or【】on the front panel to switch off the TV

2.Unplug the power cord from the AC power supply after turning off the AC power to switch the TV off completely.

Caution: The TV will be shut off automatically when the power trips. Do unplug the power cord from the AC outlet if so. The last TV mode will appear when power resumes

Do not turn on/off the TV too often

The TV will enter into Standby mode after 15 minutes when there is no signal input in TV source; The TV will enter into sleep mode after 30 seconds when there is no stynal input in PC source.

PAGE 11