Peerless Industries PLAV 60-S, PLA 60-S manual Installation to Wood Stud Wall, Skip to on

Page 4

Installation to Wood Stud Wall

WARNING

Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.

Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.

Never tighten in excess of 80 in. • lb (9 N.M.).

Do not attach directly to a metal stud wall. Use of a triple stud WSP wall plate is required for attachment to metal studs (contact customer care). Metal stud installation is not UL evaluated.

Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is highly recommended.

Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers are responsible to provide hardware for other types of mounting situations.

Never exceed the Maximum UL Load Capacity of 175 lb (79 kg).

1

Wall plate (A) can be mounted to two studs that are 16" apart. Use a stud finder to locate the edges of the

studs. Use of an edge-to-edge stud finder is highly recommended. Based on their edges, draw a vertical line

down each stud’s center. Place wall plate on wall as a template. The top mounting slots should be located .36" above the desired screen center for PLA 60 and PLA 60-S and .43" below the desired screen center for PLAV 60 and PLAV 60-S. Level plate, and mark the center of the eight mounting holes. Make sure that the mounting holes are on the stud centerlines. Drill eight 7/32" dia. holes 3" deep. Make sure that the wall plate is level, secure it using eight 5/16 x 3" wood screws (O) and washers (P).

Skip to step 2 on page 6.

WARNING

Never mount this product to metal studs without the required accessory.

P

O

A

4 of 9

ISSUED: 05-02-06 SHEET #: 202-9112-2 06-21-06

Image 4
Contents Maximum UL Load Capacity 175 lb 79 kg Tools Needed for Assembly AccessoriesJP R IV U Installation to Wood Stud Wall Skip to onInstallation to Concrete Wall IMPORTANT! Concrete must be 2000 psi density minimumDetail Assembly C I H For Plav 60 only