Peerless Industries PLAV 60-S, PLA 60-S manual Detail

WARNING

• If you are uncertain that product is properly installed, call customer care.

2	Note: There are five mounting positions. The
	center position is shown (right). Slide washer (J)

over wall support arm axle (D). Next, insert plastic cap (N) into axle. Then, insert holding pin (M) into axle. See detail 1.

N

J

D

M

2-1

2-2

Place arm assembly (C) with washer (J) into wall
plate (A). Insert axle assembly shown in detail 1	DETAIL 1
through wall plate (A), arm assembly (C), and
washer (J). Lock axle in place by aligning holding	A
pin (M) with notches shown in detail 2.
Insert socket cap screw (K) into hole at bottom of	NOTCH
wall support arm axle (D) as shown in detail 3.	C
Tighten screw using 9/64" allen wrench (Q).

DETAIL 2

Note: Fit of axle (D) into wall plate (A) and arm assembly (C) will be tight. Gently tap into place with a hammer if necessary.

	J
	K	D
		DETAIL 3
3	Snap four cable management clips(R)into top or bottom of arm assembly(C)as shown. Cable ties (S) are used
	with clips for cord management.

3-1Slide one mesh sleeve (T) over each cable. Use cable ties (S) to tighten mesh sleeves to cables.

T

R

C

S

6 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-2 06-21-06