Cord Management
Attach cable tie anchor (H) to top or bottom of wall arm (AA) using screw (J) as shown in figure 3.1. Secure cables
3to wall arm (AA) using cable tie (G) as shown in figure 3.2.
AA H
J | fig. 3.1 |
|
G
SCREEN
CABLES | fig. 3.2 |
|
OPTIONAL
NOTE: Adjustment points (socket screws) are factory torqued for optimal performance. This factory torque setting is recommended to prevent the screen from slipping over time. If more or less tension is desired follow this optional step. You may not achieve optimal torque value if factory torque settings are adjusted.
If more or less tension is desired in the tilt mechanism, do the following:
•To adjust tilt, insert a flat head screw driver into slot and remove cap covering the socket screw. Tighten or loosen socket screw no more than half a turn using 5 mm allen wrench (E) as shown in detail 2.
•To adjust roll, remove snap caps covering the
WARNING
•Do not loosen socket screws or nylock nuts to the point they become disengaged from the mount. Doing so may cause the screen to fall.
SOCKET |
SCREW |
DETAIL 2 |
SLOT
If more or less tension is desired in the arm pivot points, do the following:
•To increase tension, turn socket screw clockwise with 3/16" allen wrench (I).
•To reduce tension, turn socket screw
10-32 NYLOCK NUT
SNAP CAP
SOCKET SCREWS
6 of 20 | ISSUED: |
© 2009, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.
Peerless Industries, Inc.
3215 W. North Ave. Melrose Park, IL 60160 www.peerlessmounts.com