Peerless Industries IM740P Cable Management, Access, Plate, Cables Screen not shown for clarity

Page 6

Cable Management

4

For optional installation of electrical gang box, access plates located on the bottom or top of in-wall box can be

temporarily removed to install electrical gang box as shown in figure 4.1.

Access

plate

fig. 4.1

screen not shown for clarity

4-1

Insert up to four cable management clips (F) into the desired positions in the in-wall box as shown in figure 4.2

for routing cables. Refer to instruction included with PA740 articulating arm (AA) for cable management with arm.

Insert cable bushing (E) into top or bottom hole of in-wall box for routing cables through in-wall box. Plastic finishing caps (G) can be used in holes where cables are not being routed.

Note: Make sure cables have enough slack to allow full movement of the arm.

Use cable ties (H) to secure cables to cable management clips as shown in figure 4.3.

fig. 4.2

F

E or G

fig. 4.3

cables

H

screen not shown for clarity

6 of 6

Visit the Peerless Web Site at www.peerlessmounts.com

ISSUED: 12-04-07 SHEET #: 095-9280-3 03-25-10 For customer care call 1-800-865-2112 or 708-865-8870.

© 2007, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.

Image 6
Contents Models IM740P, IM740P-S Maximum UL Load CapacityTools Needed for Assembly Table of ContentsParts List PA740, PA740P-S articulating armRemove drywall inside cut outline Installation to Wood Stud WallBox A. Draw a second horizontal line 12-1/4 311 mm below Mount orientation as shown in figureInstalling Articulating Arm to In-wall Box Installing Screen to ArmPlate AccessCable Management Cables Screen not shown for clarity