Peerless Industries PP730-S manual Optional, Cord Management

Cord Management

3	Attach cable tie anchor (H) to top or bottom of wall arm (AA) using M4 screw (M) as shown in figure 3.1. Secure
	cables to wall arm (AA) using cable tie (G) as shown in figure 3.2.

M

H

AA

fig. 3.1

screen cables

G

fig. 3.2

OPTIONAL

NOTE: Adjustment points (socket screws) are factory torqued for optimal performance. This factory torque setting is recommended to prevent the screen from slipping over time. If more or less tension is desired follow this optional step. You may not achieve optimal torque value if factory torque settings are adjusted.

If more or less tension is desired in tilt mechanism, remove snap caps as shown in detail 2. Insert a flat head screw driver into slot and pry cap away from tilt mechanism:

•To adjust tilt, simply tighten or loosen socket screw no more than half a turn using 5 mm allen wrench (E).

•To adjust roll, simply tighten or loosen 10-32 nylock nut.

WARNING

•Do not loosen socket screws or nylock nuts to the point they become disengaged from the mount. Doing so may cause the screen to fall.

socket screw

detail 2

10-32 nylock nut snap cap

SLOT

If more or less tension is desired in the arm pivot points, do the following:

•To increase tension, turn socket screw clockwise with 3/16" allen wrench (I).

•To reduce tension, turn socket screw counter-clockwise with allen wrench (I).

NOTE: Do not turn more than half a turn.

Socket screws

6 of 20 ISSUED: 10-01-07 SHEET #: 095-9272-2 06-15-09

© 2009, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.

Peerless Industries, Inc.

3215 W. North Ave. Melrose Park, IL 60160 www.peerlessmounts.com