Mitsubishi WD-52631 manual Removing the Old Lamp Cartridge, Installing the New Lamp Cartridge

Page 94

94Appendices

Appendix C: Lamp Cartridge Replacement, continued

WARNING

THE COVER IS PROVIDED WITH AN INTERLOCK TO REDUCE THE RISK OF EXCESSIVE ULTRAVIOLET RADIATION. DO NOT DEFEAT ITS PURPOSE

OR ATTEMPT TO SERVICE THE TV WITHOUT REMOVING THE COVER COMPLETELY.

Removing the Old Lamp Cartridge

1.Turn off TV power and allow the lamp to cool for at least one hour before proceeding.

2.After the lamp has cooled, remove the cover. Refer to figure 1. Use a #2 (large) Phillips screwdriver to remove the two screws securing the cover. Keep the screws and cover for re-installation

3.With a large flat-blade screwdriver, loosen the two shiny screws securing the lamp cartridge until they disengage from the mating threads. These are captive screws and cannot be separated from the lamp cartridge.

4.Fully open up the bag supplied with the replacement lamp and set the opened bag aside.

5.Gently grasp the handle of the lamp cartridge and pull the old cartridge straight out. See figures 1 and 2.

CAUTION: Do not tilt or rotate the cartridge, as small glass fragments may fall out.

6.Without tilting or putting down the lamp cartridge, insert it into the opened bag. Close the bag while being careful not to let any glass particles fall out.

Installing the New Lamp Cartridge

1.Do not touch the glass parts of the new lamp car- tridge. Insert the new cartridge into the TV using the following guidelines:

a.Refer to figures 3 and 4 and note the location of the top and bottom guides inside the lamp com- partment and the corresponding grooves on the top and underside of the lamp.

b.Hold the lamp cartridge level with the lamp com- partment, oriented as shown in figure 5.

c.Align the grooves on the cartridge with the top and bottom guides in the lamp compartment. See figure 5.

Handle

Figure 1.

(step 5)

 

Figure 2

d.Carefully push in the cartridge until it is fully seated. If the cartridge does not slide in smoothly, gently wiggle the handle from side to side while pushing in.

Guide in lamp compartment

Figure 5

2.With either your fingers or the screwdriver, gently tighten the two shiny screws. If using a screwdriver, use only two fingers for final tightening. AVOID OVER-

TIGHTENING!

3.Replace the plastic cover and retaining screws.

4.WASH YOUR HANDS THOROUGHLY, AS THIS LAMP CONTAINS MERCURY.

Disposal of the Old Lamp Cartridge

Guides inside the lamp compartment

Figure 3

Figure 4

Grooves are on the top and underside of the lamp cartridge

Lamp under warranty: All lamps replaced under warranty must be returned to Mitsubishi. Use the return shipping label provided and send to Mitsubishi Digital Electronics, America, 1001 Cherry Drive, Suite 2, Braselton, GA 30517.

IMPORTANT: Lamps found to be without defect will be returned and charged back to the sender.

Lamp no longer under warranty: Contact your local authorities or the Electronic Industries Alliance at www.eiae.com for lamp-disposal or recycling instructions. Do not dispose of the old lamp with common trash.

Page 93 Page 95
Image 94
Page 93 Page 95
Contents WD-52631 WD-57731 WD-65731 U T I O N Serial Number Purchase Date For Your RecordsModel Number check one WD-52631WD-57731WD-65731 Retailer Name LocationContents Using Ieee 1394 Devices Operating Other Devices with the Remote ControlUsing the TV with a Personal Computer AppendicesStand Requirement Demo ModeStandby Fan Screen General Cleaning WarningsTop and Sides of the TV Unauthorized SoftwareImportant Safeguards Read, Retain and Follow All InstructionsPower Lines Page Television Overview Package Contents Special Features of Your TVDigital Cable Ready CableCARD, Models WD-57731 Guidelines for Setting Up and Using Your New Widescreen TVAdditional TV Setup Getting StartedIf You Turn Off the TV by Mistake Controlling Sound VolumeTurning the TV On or Off Changing ChannelsTV Front Panel System Reset ButtonReset InputPOWER/TIMER Indicator Lamp IndicatorStatus Indicator LED Color TV Condition Additional InformationCableCARD Technology Using a CableCARDCableCARD menu Network Setup CableCARD MenuCableCARD Slot TV Back PanelANT 1/MAIN, ANT 2/AUX Antenna Input 1 and 2 InputsComponent 1 and 2 Inputs Hdmi 1Page TV Connections More About Auto Input Sensing Before You BeginChoosing a Language for Menus Ieee 1394 ConnectionsDigital Video and Home Recording Connection Type into the TV Effect on Home RecordingVideo and Combined Audio/Video Connections Picture Quality Name Signal TypeConnection Types Audio-Only ConnectionsINPUT/AUDIO Left and Audio Right on the TV back panel Nent /AUDIO Left and Audio Right onWall Outlet Cable no cable box Can be used with a CableCARD, models WD-57731For an antenna with flat twin leads Antenna with a Single LeadAntennas with Separate UHF and VHF Leads For cable or antenna with coaxial leadOptional VCR to an Antenna or Wall Outlet CableAudio in on the VCR to Monitor OUT Left VCR to a Cable Box Audio & Video Monitor OUT/LEFT and Right on the TV back panelConnecting an Hdmi device Receiver Stereo System DVD Player with Component VideoTo connect an analog A/V receiver Older Cable Box CamcorderTV Operation Record/Playback Keys Remote ControlOverview VOLResetting the Remote Control Battery InstallationSleep Timer Low-Battery IndicatorChoosing a Program Source Using ChannelViewFeature Instructions ChannelView Channel ListingsDigital Program Status DisplayAnalog Program Digital Ieee 1394 DeviceDVD Definitions TV Signals and Display FormatsSignal Definitions TV Display Format DefinitionsTV Display Formats See descriptions on the precedingSplit Screen Operations Instructions Split ScreenOperation Pause. PressTV Inputs for Split Screen Split Screen DisplaysANT Input Component Page TV Menu Settings 3D Graphical Menu System Remote Control ButtonsMenu Screens Main Menu Language Setup Menu Setup MenuClock Setup Menu Memorize Channels Setup MenuDevice Setting the Clock AutomaticallySet Time ChannelDVD Input Name MenuIcon Order Menu DVD2 VCRChannel Menu TerminologyFAV Setup Using Only the Remote Control FAV Setup Using the Channel MenuUsing FAV Channels FAV Channel MenuCaptions Menu FontBackground SizeColor Opacity FontLock by Time Parental Lock Menu Parental Lock MenuFront Panel Lock Parental Lock Menu Ratings Menu Other Ratings MenuBypassing the Ratings Lock and Lock by Time TV Ratings Chip Signal InformationTV Content Categories Movie RatingsAudio/Video Menu Analog-Only Audio Settings Audio SettingsAnalog and Digital Audio Settings Digital-Only Audio SettingsPersonal Computer Video Settings Video SettingsContrast Brightness TV Menu Settings Operating Other Devices with the Remote Control Functions Available for Other A/V DevicesMethod 2 Code Search Programming the Remote ControlMethod 1 Code Entry Code VerificationAudio Lock Universal A/V Receiver Control Resetting the Remote ControlProgramming Codes Audio Amplifiers Brand CodeKLH GPXJBL CD Players Brand CodeCable Boxes Brand Code DVD Players/Recorders Brand Code NSCTFC AMWNEC JSISVA GOI Laser Disc Players Brand CodeSatellite Receivers Brand Code HTSVCRs and DVRs Brand Code STS TMKPage Using the TV with a Personal Computer To Remove the Computer Icon from the Input Selection Menu SetupVideo Adjustments PC -DVI Audio jackComputer with DVI Monitor Output Connecting a Computer to the TVComputer with Hdmi Monitor Output Connecting a computer with a VGA 15-pin monitor output Computer with VGA 15-Pin Monitor Output Analog VideoAdjusting Image Resolution Select Control PanelFormat 16 X 9 Standard 3 Standard Available for your computer’s video signalAs Displayed on TV Screen 640 XUsing Ieee 1394 Devices Direct Device-To-Device Method OverviewHub Connection Method Ieee 1394 Amplifiers Tips for Connecting Ieee 1394 DevicesIeee 1394 Devices and the Input Selection Menu Ieee 1394 CamcordersRecording Signal Type TV Input Immediate Recording from the Recording Setup MenuTime-Delayed Recording from the Menu Recording to Ieee 1394 Recordable DevicesTo Cancel a Scheduled Recording Time-Delayed Recording from ChannelViewTo Cancel a Recording in Progress Immediate Recording from ChannelViewTo Power On or Off a Compatible Ieee 1394 Device TV Remote Control and Ieee 1394 DevicesOperation of Ieee 1394 Devices with the TV’s Remote Control Retention Period DiscsTo Copy a Track to Another Ieee 1394 Device Switching Between Analog and Digital Ieee 1394 Outputs Appendix B Specifications Appendix D TroubleshootingPage Appendix a Bypassing the Parental Lock Bypassing the Parental LockThis page intentionally left blank Picture Technology Appendix B SpecificationsInputs Description Qty Signal Type Input Specifications ReceptionDigital Interfaces Outputs Description Qty Output SpecificationsHdmi Lamp Appendix C Lamp Cartridge ReplacementTo Order a New Lamp Disposal of the Old Lamp Cartridge Installing the New Lamp CartridgeRemoving the Old Lamp Cartridge TighteningReset Name When to Use How to Use Resulting Action Appendix D TroubleshootingTV Reset Functions Demo Mode Off buttonService Service and SupportSupport General TV Operation Symptom Remarks TV Channels Symptom RemarksTV Power On/Off Symptom Remarks Picture Symptom RemarksIndicators Symptom Remarks Sound Symptom RemarksIeee 1394 Recording Symptom Remarks Ieee 1394 Devices Symptom RemarksAppendix D Troubleshooting Trademark and License Information Mitsubishi TV Software 103To Obtain Warranty Service 104105 This Limited Warranty does not CoverMitsubishi Digital Electronics AMERICA, INC Index VCR Demo Mode MDEAservice@mdea.comSystem Reset
Top Page Image Contents