Connecting the Mediamaster to the satellite dish

Connecting the Mediamaster to the satellite dish

Installing the satellite dish

ŸYour satellite dish should be installed with a cable for you to connect to the Mediamaster. If you do not have this cable you will need to buy one from a dealer (tell the dealer you need a coaxial cable and F-connectors).

ŸConnect the cable from the satellite dish to the socket marked ”LNB IN” on the back of the Mediamaster.

If you need to fit the F-connectors onto the cable

Prepare each end of the cable as shown in the diagram. You will need to fold back the outer braid (as shown).

ŸSlide the F-connector onto the cable, and then turn it clockwise until it grips the braid.

ŸEnsure that 3 mm of the core is protruding from the end of the connector.

15mm

8mm

F-connector

3mm

Connecting the Mediamaster to a TV set

There are many different types of TV/VCR and other equipment that you can connect to the Mediamaster. In this manual you will see some of the most common ways to connect your equipment. If you use RF cables you will have to tune your TV and VCR to the Mediamaster output channel. If you have problems with your connections and need help, contact your dealer or Service Provide.

ŸConnect the SCART cable between the main SCART socket on the TV and the TV SCART socket on the Mediamaster.

ŸConnect an RF cable from the TV/VCR output on the Mediamaster to the RF input socket on the TV.

ŸConnect the TV aerial to the TV AERIAL input socket on the Mediamaster.

GB 6