Hyundai IT HQL260WR, 320WR manual FCC Information, User Instructions

Page 2

FCC Information

User Instructions

The Federal Communications Commission Radio Frequency Interference Statement includes the following warning :

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television receptions, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures :

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for assistance.

User Information

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Connecting of peripherals requires the use of grounded shielded signal cables.

Image 2

Contents U N D a I I M a G E Q U E S T L C D T FCC Information User InstructionsDeclaration of Conformity Prevention Important TipsCause Pixel DefectPanorama, Wide, 43 aspect ratio Box or Still image Image Sticking PrecautionPrecaution You can adjust Aspect Ratio as you want You can display teletext information at any time on your TVTable of Contents Safety Precaution Do not install on an unstable place Firmly plug in the power cord so that it does not pull outDo not use a damaged power cord or plug, or loose outlet Or small support There is poor air circulationNever attempt to open, fix, or modify the LCD TV Do not block ventilating slitsDo not install the product on the floor Unplug when you do not use your LCD TV for a long time Do not allow children to climb or play on the LCD TV+ and marks in the battery compartment Contents of the Package How to Use the Kensington Security Slot Kensington Technology GroupHow to Use the Rear Cap and Cable Holder Connect your cables to the terminals of the rearHow to Adjust the View Angle Angle AdjustmentOption How To Install Wall Mount SupportParts configuration chart How To Install Wall Mount Frame Installation MethodFront View Rear View Use this button to select TV input source Use this button to turn the TV set on or offUse this button to turn the sound off completely Use this button to return to the previous channel. Still PHow to Insert Batteries in Remote Control General Information Connections Connecting Indoor/Outdoor TV AntennaUHF/VHF PressConnections Before connecting the video connections to external devices Connect cables and terminal in the same colors Connecting a VCR, Cable/Satellite ReceiverVideo/S-Video input terminal of LCD TV Receiver and Audio input terminal of LCD TVConnecting a DTV Receiver or DVD Player For DTV/DVD Audio on the rear of LCD TVPlaying Back a Tape Recorded On a Camcorder LCD TV Connecting to a PCOn remote control unit to select PC Resolutions Supported in PC Resolution Horizontal frequency Vertical frequencyScart Connection to the External Input/Output Scart Pin Specifications Scart 1 Full ScartConnections Picture Setup How to Select the Picture Mode How to Set the Desired Picture Press the Position button, then position How to Set PIP ModeThis function is available only with the remote control Press the Size buttonVideo AV1 Video AV2 Video Scart1F Scart2H Supported PIP TablePress the Swap button Press Left, Right or OK button to move to select Geometry How to Set the Geometry In PC modePress Up and Down buttons to move to Geometry Geometry menu appearsHow to Set the Geometry In DTV mode Picture Setup Sound Setup Sound How to Select the Audio ModeHow To Directly Select Sound Mode Press button EqualizerThen Press Up and Down buttons to adjust How to Set the Desired AudioUsers can manually adjust the sound in thier own ways Press Up and Down buttons to move to SoundPress Left, Right or OK button to select Sound How to Set the Balance, Volume and Sound SourceThen Press Left and Right buttons to adjust Previous menuHow to Select SRS WOWSurround Dual 1 Your national language Dual 2 Foreign language How to Listen to Stereo Sound / Dual SoundPress the button on the remote control to select Dual sound Nicam Sound Setup Channel Setup How to Store Program Automatically Be DE ES FR IT NL SE CH UK E/EURO OthersPress Left and Right buttons to select to How to Edit Program ManuallyPress Left and Right buttons to set to Manual Tuning Then colour system changes in order belowPress OK button to select Program Edit Program Edit menu appearsDelete Teletext Feature Teletext OSDOn-Screen-Display PictureDisplaying the Teletext Information Selecting Display OptionsDisplays the next Displays the previousFunction Setup PIP image will change only from 43 to How to Select the Aspect RatioPress the Aspect button, then Aspect Ratio To deselect Still function How to Freeze PicturePlaying picture is stopped Press Still button once moreHow to Set Key-Lock Off Once AlwaysHow to Set OSDOn-Screen-Display Display Time Press Left and Right buttons to adjust the OSD display timeHow to Set No Key Operation Auto Power Off Press Up and Down buttons to move to No Operation TimeoutHow to Set No Signal Timeout Favorite Channel menu appear How to Set Your Favorite ChannelsHow To Directly Select Favorite Channel Press button Channel or input source are changed in order belowHow to Set Noise Reduction and Use Factory Preset Go to step If you need to recall to the defaultDisplaying Information and Clock Press the Info buttonEnglish, Français, Deutch, Italian, Español When it selects, the mark is indicatedChoosing Your Language Press Left, Right or OK button to select LanguageFunction Setup Clock Setup How to Set Date and Clock Press Up and Down buttons to move to ClockHow to Set On/Off Time Go to step If you need to set the Off Time Press Up and Down buttons to move to Off timeAfter the set is completed Press the Left and Right buttonsHow to Set Sleep Time Appendix Glossary From 300 to 3,000 megahertz Showbiz interviews, film & theatre reviews and net issuesSatellite Multimedia such as video, game, and audio application, etcTroubleshooting How can I install an Refer to pages 23~24 Antenna?Zero, which causes the programmed time to be erased Select sound balance and make proper adjustment.When the batteries are worn out, replace with new ones Located far away from a TV broadcasting stationScreen Cleaning Care and CleaningCabinet Cleaning Cleaning InsideProduct Specifications Model