Hyundai IT 320WR Zero, which causes the programmed time to be erased, Cable broadcasting receiver

HYUNDAI LCD TV HQL260WR/320WR

Auto On does not work.	Ensure to use the remote control or power button on the product to turn off your
	TV. If you unplug the power cord, the stand-by consumption power becomes 0
	(zero), which causes the programmed time to be erased.
After setting the time,	Ensure to use the remote control or power button on the product to turn off your
I turned TV off and turn it on.	TV. If you unplug the power cord, the stand-by consumption power becomes 0
The programmed information	(zero), which causes the programmed time to be erased.
has been erased.
Sound Problems
Symptom	Possible solution
Too much noise occurs.	Check whether the audio setting is in the Stereo mode. In the Stereo mode, the
	sound may be distorted in the area where experiences poor reception or is
	located far away from a TV broadcasting station.
No sound while viewing a	Make sure an audio or audio/video component is securely inserted into the
cable channel	appropriate jacks. Check other channels for sound. Check the volume settings on
	the cable broadcasting receiver.
Picture is OK but sound does	Try to press volume up/volume down buttons of your remote control.
not come out.
One of the speakers does not	Select sound balance and make proper adjustment. (Page 45)
produce sound.	Check the speaker connection cables.
General
Symptom	Possible solution
Remote control won't work.	Check whether there is a blocking object between the remote control and LCD TV.
	Make sure your LCD TV is Power On. (In case of normal, LED on the front panel is
	in Red.)
	Check whether batteries are inserted with proper polarities(+, -).
	When the batteries are worn out, replace with new ones.
Where does the S-Video	Connect the two Audio jacks from the S-Video cable to the left and right ports on
cable plug in for audio	the Composite.
output?
Strange noises are heard.	Ticking noise during or after watching is caused by the change of ambient
	environment such as humidity and temperature, which is characterized by plastic
	products. Strange ticking noise occurs because a signal is suddenly transmitted
	to the LCD panel. So, this is not a malfunction.
I tried to use the TV screen	Adjust the resolution referring to the standard signal mode table. Check the
as a PC monitor	specification of your video card installed in your PC. If your video card does not
but it doesn’t work.	work in supported hardware. Try upgrading the video card’s driver.

APPENDIX

80