Setup and Connections
■Ensure that the power switch of this unit and other equipment to be connected is set to off before commencing connection.
■Do not block ventilation holes of any of the equipment and arrange them so that air can circulate freely.
■Read through the instructions before connecting other equipment.
■Ensure that you observe the color coding when connecting audio and video cables.
Connecting to a stereo TV and stereo or Pro Logic Amplifier/Receiver
TV
To
To stereo audio input connector
(Red/White) on the TV or Stereo/Pro
Logic Amplifier/Receiver
To Video input | To power outlet |
connector (Yellow) | (AC 230V/50 Hz) |
DVD
Notes:
■The Video output (yellow) combines the com- plete video signal (composite) and sends it to the TV (or to the AV Receiver) by one line only. Use the Video output, when your TV set is equipped with a Video input jack only.
■The S (separate) video output connector sepa- rates the color (C) and luminance (Y) signals before transmitting them to the TV set in order to achieve a sharper picture. Use the
for improved picture clarity. Never connect both outputs, Video and
■Most European TV´s are equipped with SCART connectors rather than with a normal video input (yellow cinch). In that case the SCART connection should be used, providing the audio signal too. Separate analog audio con- nections to TV are needed only if your TV is connected to the video or
■When the audio signal is to be fed to a stereo or Pro Logic amplifier/decoder or receiver rather than to the TV, connect the Audio Out jacks to any normal audio input on your amplifier/decoder/receiver. The DVD will ”downmix” Dolby Digital recordings to Pro Logic, available on these connectors, all ana- log surround or stereo signals will be fed to them directly.
You can also select the audio and video sig- nals of all your video devices with your AV Receiver/Amplifier. For more information see ”Note” on next page.