Memorizing the Channels (continued)
Setting Auto Fine Tune (AFT)
1 Repeat steps 1~4 in [Selecting the Signal Source] to
2
3
When the AFT is set to On, the unit will automatically tune the program frequency to provide the best possible
search |
|
|
|
source | antenna | cable | |
autoset | <select> to enable |
| |
auto fine tune |
| off | on |
fine tune |
|
| 50 |
channel skip |
| off | on |
right/left to adjust automatic fine tune |
|
Manual Fine Tuning
1 Repeat steps 1~4 in [Selecting the Signal Source] to
2
3 Press VOL+/- to fine tune till the best possible picture and sound are obtained.
If you fine tune a program manually, the auto fine tune
search |
|
|
|
source | antenna | cable | |
autoset | <select> to enable |
| |
auto fine tune |
| off | on |
fine tune |
|
| 50 |
channel skip |
| off | on |
right/left to adjust fine tuning |
|
|
Adding and Erasing Channels
1 Use number buttons to directly select a channel that will be added or erased.
2 Repeat steps 1~4 in [Selecting the Signal Source] to
3
4
When the item is set to on, the selected channel will be erased. When the item is set to off, the selected channel will be added.
The erased channels can not be selected by using the CH/ buttons unless you use number buttons to
search |
|
|
|
source | antenna | cable | |
autoset | <select> to enable | ||
auto fine tune | off | on |
|
fine tune |
|
| 50 |
channel skip | off | on | |
right/left to set channel skip |
20