Chapter 5: DVR Setup - 5.2 Camera Select
The DVR system can display 4 camera feeds in one picture (Quad Mode).
Users can configure which camera is displayed.
Press [ | Select] to modify setting and press [ CH1], | |
[ CH2], [ CH3],[ | CH4] to set each channel | |
separately. |
| |
If the channel is disabled, the system will display | ||
OFF | on the monitor. | |
Chapter 5: DVR Setup - 5.3 Record Select
Configure which channels are allowed to record.
Note: If no channels are selected, an error message will appear briefly on the screen when record is selected.
Chapter 5: DVR Setup - 5.4 Record Mode
There are two modes of resolution for video recording
1.Each Mode: The DVR compresses and records each video channel separately so the user can enlarge a single channel to full screen display and still be recording on all channels. You can also record on specific channels, for example, user can turn off the record function of CH1 and CH2 and then the system will only record video on CH3 and CH4.
Press [ 
CH1], [ 
CH2], [ 
CH3], [ 
CH4] to switch between channels when playing back recorded video.
In Each Mode user can use the Loop Function.
Loop Function: When the system is in Live mode or Recording mode,press the
SEARCH TIME
|
|
| 1 |
|
| 2 |
2008/01/08 | 08:30:56 | 2008/01/08 | 16:00:35 | |||
3 | 01 | TIME | 2008/01/08 | 15:50:20 | ||
*02 | TIME | 2008/01/08 | 14:30:56 | |||
| 03 | TIME | 2008/01/08 | 14:15:30 | ||
| *04 | TIME | 2008/01/08 | 14:00:15 | ||
5 | *05 | MOTION | 2008/01/08 | 13:55:37 | ||
0 6 MOTION | 2008/01/08 | 11:30:12 | ||||
4 | 07 | MOTION | 2008/01/08 | 10:15:30 | ||
08 | MOTION | 2008/01/08 | 08:30:55 | |||
(UP,DOWN) MOVE | (PLAY) PLAY | (MENU) EXIT |
(FF) SELECT MODE (SELECT) CHANGE |
| |
1. Start Time. | 2. End Time. |
3. TIME: Continuous record. | 4. MOTION: Motion Triggered event. |
5. |
|
Chapter 8: USB DVR Access - 8.1 Program Installation
1.Put the USB Driver Program CD in your
3.Double click on Set up .
4.Run the install DVR Viewer program.
To Run the program Double click the program icon [ 
] on the desktop. DVR Viewer will detect the hard drive automatically when user connects the USB cable to PC.
NOTICE: If the hard drive isn't detected, please restart and try the following:
] then reconnect the USB cable to the PC and try again.
Page 9 | Page 18 |