Q-See user manual DVR Setup 5.15 NTSC/PAL Output Selection, DVR Setup 5.16 Factory Reset

Q-See Q25DVR4ES User's Manual

Chapter 5: DVR Setup - 5.15 NTSC/PAL Output Selection

Change the J10 jumper on the system board to select NTSC or PAL video

output as marked on the silkscreen of the system board.

NTSC/PAL Select

Chapter 5: DVR Setup - 5.16 Factory Reset

Press the [SEL] Button to reload factory defaults, then the DVR will reboot, all custom settings (including password) will be restored to default.

There is no confirming dialog box for this selection after you press [SEL] button, the system will just reboot!

Q-See Q25DVR4ES User's Manual

Chapter 5: DVR Setup - 5.10 Sub Menu-Password Change

System default password: Press [ CH1] button six times.

User needs to enter six characters for the password.

All keys can be used as password key except the [ Menu] key, which is used to exit.

Note: To Reset the DVR.

Press the [Pause] button 10 times.

Resetting the DVR restores all values to system defaults and the DVR will reboot.

Afterward the default password is [ CH1] button 6 times.

Chapter 5: DVR Setup - 5.11 Sub Menu- Color Set

HUE : 0-99.

SATURATION : 0-99.

CONTRAST : 0-99.

BRIGHTNESS : 0-99.

Button function :

[ Up] [ Down]: moves the prompt.

[REW]: Increase Value.

[FWD]: Reduce Value.

[CH1-CH4, QUAD]: Select Channel.

[ Menu]: exit.

Page 15 Page 12