Q-See QSD004 manual Motion Set, Motion SET Motion Record Time

Page 14

QSD004 User’s Manual

5.14 Motion Set

MOTION SET

 

MOTION RECORD TIME:

10

MOTION ALARM TIME:

OFF

MOTION SET

 

 

PRESS (UP, DOWN),

ENTER (SELECT)

PRESS (MENU) TO

EXIT

 

 

 

 

MOTION SET:

MOTION RECORD TIME:

This number indicates how many seconds the motion detection recording continues after a motion triggered event ends.

MOTION ALARM TIME:

This number indicates how many seconds the buzzer inside the DVR will sound after the DVR has been triggered by motion.

CONT: Continuous alarm until press any key to stop.

OFF: No alarm

MOTION DETECTION SET

>CHANNEL 1 SENSITIVITY 4

CHANNEL 2 SENSITIVITY 4

CHANNEL 3 SENSITIVITY 4

CHANNEL 4 SENSITIVITY 4

CHANNEL 1 AREA SET

CHANNEL 2 AREA SET

CHANNEL 3 AREA SET

CHANNEL 4 AREA SET

PRESS (UP, DOWN),

ENTER (SELECT)

PRESS (MENU) TO

EXIT

AREA SET:

SENSITIVITY:

Use [Up] and [ Down] button to

select the channel you want to modify,

press [SEL] to adjust sensitivity of

motion detection on each channel.

High (1----------

9, OFF) Low

When it’s “OFF”, the channel cannot be triggered by motion.

Use [Up] and [ Down] buttons to select the channel you want to modify, press [SEL] button to enter the sensitive area of each camera. The picture of the selected channel is divided into 144(12*12) blocks, press [REW] to move left, press [FWD] to move right, press[Up] and [ Down] to move the cursor up and down, press [SEL] to set the block active or not.

When the block is transparent, it’s active to record. When the block is covered by shadow, it is not active, and motion in this area will NOT be detected.

Make sure Record Schedule is set to Motion for the times required.

- 11 -

Image 14
Contents Page DVR Setup InstallationSystem Boot LayoutRecording AppendixFront Panel DVR FeaturesLayout Remote Control Rear PanelConnecting Power Supply Installing Hard DriveConnecting Camera and Monitor Recovering Lost Data System BootDetecting Installed Hard Drive Restore Recording FeatureMenu Directory DVR SetupSetup Menu Main ScreenCamera Select Record SelectResolution Record FrameRecord Quality Schedule SetMiscellaneous Menu-Color Set Miscellaneous Menu-Password ChangeMiscellaneous Menu-Auto Record Miscellaneous Menu-Time Set Hard Disk SetMotion Set Motion SET Motion Record TimeRecording Video ModeFactory Reset Start RecordingStop Recording Recording Time on Hard DrivePlayback Program buttons USB ProgrammingPC Viewer Program PC Backup QSD004 User’s Manual RemarkSpecifications DescriptionAppendix See Product Warranty Customer Information Card