Revox Recontrol M207 user manual Turning the touch screen on, Precautions for using battery

Page 9

Re:control M207 User’s Manual

1.3.1 Precautions for using battery

Please pay attention to the following instructions:

1.Be sure that the positive (+) and negative (-) polarities of each battery match the polarities indicated in the compartment.

2.Do not expose the batteries to excessive heat or flame.

3.Keep the batteries away from children.

4.Low power batteries will reduce the effective distance of the unit.

5.Do not mix different type of batteries or mix new and used batteries to use at the same time.

If you use Ni-MH rechargeable batteries, please pay more attention to the followings.

a.Before the first use, please charge the batteries for 10 hours.

b.Do not recharge the batteries with an unqualified charger.

c.When the battery low power warning icon appears, please recharge batteries right away.

d.Please renew the batteries immediately when its running time left is lower than half of preliminary after they are fully recharged.

Warning: When the battery low power warning icon appears, you may not enter the Setup Menu to operate the functions such as using learning function, adding a Macro, or deleting devices.

1.4 Turning the touch screen on

There are three ways to turn on

Re:control M207:

1.Picking up the Smart Remote: The motion detector design will turns the Re:control M207 on.

2.Pressing any rubber key.

3.Taping the LCD touch screen.

Figure 2-2: Turning the LCD on

6

Image 9

Contents Recontrol M207 Preface About this manualCopyright Page Table of Contents Menus Introducing Recontrol M207 Unpacking the Recontrol M207 Recontrol M207 FeaturesRemove battery cover Installing BatteryTurning the touch screen on Precautions for using batteryFront side of the recontrol M207 Identifying ComponentsRear side of the Recontrol M207 Battery compartmentSetup mode function Device normal function Direct Access Buttons Rubber ButtonsLCD Touch Screen Precautions of using touch screenTouch screen buttons Touch screen keysMain Menu Basic Information Layout Setup Menu Layout Introducing Recontrol M207 Re-calibrate the screen Quick StartDate / Time setting Device setting Quick Start How to Set Your Recontrol M207 Add a DeviceCreate a new device How to Set Your Recontrol M207 Pre-code Load the codes for the newly-added deviceHow to Set Your Recontrol M207 Learning How to Set Your Recontrol M207 Learning Learning fail Successfully Add a Soft KeyHow to Set Your Recontrol M207 Add a Text Re-label a Device, Key or Text Select Icons Re-size a Device, Key or Text Recontrol M207 User’s Manual Delete a Device, Key or Text Pre-code How to Set Your Recontrol M207 Recontrol M207 User’s Manual Learning Recontrol M207 User’s Manual Learn a Cycle key Recontrol M207 User’s Manual Delete Device/Key codes Macro Create a MacroPlease press the button to confirm your decision An Example to Add a Macro Create a Timer Macro Timer MacroRecontrol M207 User’s Manual Delete Your Timer Macro Re-label Your Timer Macro View Your Timer Macro Add the favorite channel keys Create Your Favorite ChannelsSet these Macros as your favorite channels Menus SettingPower TimeContrast LCD Off Light SensitivityLight Period Reset MotionWelcome Page 2. Please use Add Text Key LayoutRe-size DeleteCode Setting Timer Macro Re-labelView Duplicate Recontrol M207 User’s Manual Calibrate Install USB Cable and Software Install Reconnect USB cableInstall the Driver Install USB Cable and Software Install Upgrade Tools Install USB Cable and Software Upgrade Vmcu Firmware and Vmcf Pre-programmed Codes Install USB Cable and Software Recontrol M207 User’s Manual Appendix a FeaturesCD, AUX SpecificationsAppendix B Optional AccessoriesAppendix C Troubleshooting TablesTroubleshooting Tables