Revox user manual Rear side of the Recontrol M207, Battery compartment

Page 11

Re:control M207 User’s Manual

1.5.2 The rear side of the Re:control M207

Figure 1-2: Rear view

1.IR Port

You can point the IR port at the IR receiver of targeted device to control the unit.

2.Reset switch

You can reset the Re:control M207 while the Re:control M207 can’t work properly or hang on.

3.Back label

Back label marks the model number and the briefly specifications.

4.Buzzer hole

Beeps signal are released from here.

5.Battery compartment

You can remove the cover to replace the 3xAAA alkaline batteries or Ni-MH rechargeable batteries.

6.Learning eye (P.37)

The Re:control M207 receives the IR codes from here and saves the corresponding codes. Makes the original remote control point at the Learning eye of the Re:control M207 and press the corresponding buttons to send out the IR signals. In this way, the Re:control M207 will learn the IR codes from your original device.

8

Image 11

Contents Recontrol M207 Copyright PrefaceAbout this manual Page Table of Contents Menus Introducing Recontrol M207 Unpacking the Recontrol M207 Recontrol M207 FeaturesRemove battery cover Installing BatteryTurning the touch screen on Precautions for using batteryFront side of the recontrol M207 Identifying ComponentsRear side of the Recontrol M207 Battery compartmentSetup mode function Device normal function Direct Access Buttons Rubber ButtonsLCD Touch Screen Precautions of using touch screenTouch screen buttons Touch screen keysMain Menu Basic Information Layout Setup Menu Layout Introducing Recontrol M207 Re-calibrate the screen Quick StartDate / Time setting Device setting Quick Start Create a new device How to Set Your Recontrol M207Add a Device How to Set Your Recontrol M207 Pre-code Load the codes for the newly-added deviceHow to Set Your Recontrol M207 Learning How to Set Your Recontrol M207 Learning Learning fail Successfully Add a Soft KeyHow to Set Your Recontrol M207 Add a Text Re-label a Device, Key or Text Select Icons Re-size a Device, Key or Text Recontrol M207 User’s Manual Delete a Device, Key or Text Pre-code How to Set Your Recontrol M207 Recontrol M207 User’s Manual Learning Recontrol M207 User’s Manual Learn a Cycle key Recontrol M207 User’s Manual Delete Device/Key codes Macro Create a MacroPlease press the button to confirm your decision An Example to Add a Macro Create a Timer Macro Timer MacroRecontrol M207 User’s Manual Delete Your Timer Macro Re-label Your Timer Macro View Your Timer Macro Add the favorite channel keys Create Your Favorite ChannelsSet these Macros as your favorite channels Menus SettingContrast PowerTime Light Period LCD OffLight Sensitivity Welcome Page 2. Please use ResetMotion Delete Key LayoutAdd Text Re-sizeCode Setting View Timer MacroRe-label Duplicate Recontrol M207 User’s Manual Calibrate Install the Driver Install USB Cable and SoftwareInstall Reconnect USB cable Install USB Cable and Software Install Upgrade Tools Install USB Cable and Software Upgrade Vmcu Firmware and Vmcf Pre-programmed Codes Install USB Cable and Software Recontrol M207 User’s Manual Appendix a FeaturesCD, AUX SpecificationsAppendix B Optional AccessoriesAppendix C Troubleshooting TablesTroubleshooting Tables