Installation Instructions |
ASSEMBLY and INSTALLATION
Install Arm Assembly/Wall Plate to Wall Wood Stud Installation
WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.
IMPORTANT ! : The
1.Level arm assembly/wall plate (A) and mark locations of pilot holes. (See Figure 1)
2.Drill 1/4" (6.4mm) diameter pilot holes into wood supports. (See Figure 1)
3.Install 3/8 X 2 1/2" lag screws (X) through flat washers (Y), arm assembly/wall plate (A), into wood supports. (See Figure 1)
| 1 | x 4 |
2 | x 4 |
|
1/4" (6.4mm) |
| |
| (A) |
|
(Y) x 4 |
| |
3 | (X) x 4 |
|
9/16" (14.3mm) |
|
Figure 1
Concrete Installation
WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.
IMPORTANT ! : The
1.Level wall plate and mark locations of pilot holes. (See Figure 2)
2.Drill 3/8" (9.5mm) diameter holes into concrete. (See Figure 2)
3.Install anchors (S) into holes. (See Figure 2)
CAUTION: Do not overtighten lag screws (X)!
4.Install 3/8 x 2 1/2" lag screws (X) through flat washers (Y), wall plate (A), into anchors (S). (See Figure 2)
1 | x 4 |
|
2 | x 4 |
|
3/8" (9.5mm) |
| |
| 3 | (S) x 4 |
| (Y) x 4 |
|
4 | (X) x 4 |
|
9/16" (14.3mm) |
|
Figure 2
6