Installation Instructions | ||
Cover Plate Installation |
| |
1. | Install four cover plates (T) using four |
|
| pan machine screws (V) and four spacers (W). Insert screw |
|
| into cover plate and add the spacer before inserting the |
|
| cover plate tab into the arm assembly/wall plate. (See |
|
| Figure 3) |
|
| 2 | x 4 |
| Place tab |
|
| into slot |
|
| (T) x 4 |
|
| (W) x 4 |
|
| Figure 4 |
|
| level with top of washers | (46" or 55" models) |
Figure 3
Installing Interface Brackets to Display
1. Place display face down on a soft,
2.Remove four sets of bolts and washers that were shipped
attached to the back of the display. Set hardware aside for
WARNING: The bolts and washers are designed to be |
|
|
|
|
permanent fixtures on the television. Never remove the bolts | (D) x 2 |
|
| |
or washers except for installation of the wall mount! Always |
| just above rubber sealing gasket | ||
replace bolts immediately. Installing the television without the | level with top of washers | (65" models) | ||
bolts and washers may result in serious personal injury and/ |
|
|
|
|
|
|
|
| |
or damage the television! |
|
|
|
|
3.Place interface brackets (C or D) on the back of the display
so that they align with the holes on the display. Use removed screws and washers to loosely attach interface brackets to display. (See Figure 5)
NOTE: Use short brackets (D) if installing to 46" or 55" models and long interface brackets (C) if installing to 65" models.
4. Align bottom of the brackets with rubber sealing gasket and the top of the brackets with the top of the washer. (See Figure 5)
(C) x 2 | just above rubber sealing gasket |
Figure 5
7