Setup

(Note: Before connecting computer, ensure the resolution and refresh rat e of the computer do not exceed the

following setting s - resolution: 1280*1024, refresh rate: 75Hz.)

1.1Turn off your computer

1.2Connect the video signal cable to the VGA port of your PC, tighten the screws on the connector onto the computer

1.3Connect the other end of the video signal cable to the VGA-IN port at the back of the monitor, tighten the screws on the connector to the monitor

2.Connecting power

2.1Plug the female end of the power cord in to the AC-IN port at the back of the monitor

2.2Plug the male end of the power cord into a power outlet

3 Connecting audio (optional)

3.1Plug the audio cable into the AUDIO port at the back of the monitor

3.2Plug the other end of the audio cable into your computer or other audio source

4.Turning on the computer

Pressing the

button at the back of the monitor to turn on the monitor

6.Removing the protection film from the monitor

You should be able to see the picture now. I f not, refer to the “Troubleshooting” section.