Insignia PBS1DTV Install the remote control battery, Connect the AC adapter, Establish a signal

Step 2 Install the remote control battery

Remove the battery holder from the back of the remote control by inserting a fingernail into the groove and pulling out the holder. Place a CR2025 battery with the + side up on the holder. Insert the holder into the remote control.

1

2

Note: The coin-shaped battery is already in the remote control. The first time you use the remote control, remove the plastic sheet from the bottom of the battery to activate the remote.

Step 3 Connect the AC adapter

Connect the AC adapter into the DC IN jack on the right side of your unit, then connect the AC adapter to a 100-240V power outlet.

Step 4 Charging the built-in battery

Note: There is no standby mode for this TV, because it runs on a rechargeable battery.

Turn off your TV before charging the battery. Connect the supplied AC adapter. Charging starts, and thePOWER ON/CHG indicator is red. When the charging is completed, the indicator turns off.

Note: On initial use of the TV, charge the battery for 6 hours.

Step 5 Establish a signal

Make sure that the included rod antenna or a stronger HDTV antenna (not included) is attached to the input at the top of the TV. Extend the antenna rod and move the TV to a location where it can receive the strongest signal, free of obstructions and interference from other devices. Press TV on your remote control to ensure you are in TV mode.

Step 6 Scan for channels

Note: See your User Guide for more information on connecting your TV directly to cable or satellite service and for scanning for radio stations.

To scan for channels when the TV signal source is Antenna

Press MENU on the remote control, using the		buttons to		Antenna/Cable	Antenna
				Auto Channel Search
highlight	(channel icon). The Channel menu opens. Press
				Add/Skip Channels
OK/ENTER or	to enter the Channel menu. Press the		buttons	Favorites	80.3
to select Auto Channel Search, then press OK/ENTER or			to enter	Channel No.
				Channel Label	PBS1DTV
the Auto Channel Search menu. Start to Scan is highlighted. Press
				Select OK:Enter	Menu:Exit
OK/ENTER or	to start the scan.

If the Automatic Channel Search does not locate the channels you were expecting, try moving the TV to a location where you can pick up a stronger signal, then try rerunning the search.

© 2009 Best Buy Enterprise Services, Inc. All rights reserved. INSIGNIA is a trademark of Best Buy Enterprise Services, Inc. Registered in some countries. All other products and brand names are trademarks of their respective owners. ENGLISH 09-0339