Vermont Casting 2479 manual Fan Kit Installation

6.Reposition the stove so the other front corner over- hangs the pallet and remove the leg bolt from the bottom of the stove. Align the leg with the bolt hole in the bottom of the stove, and attach it with the bolt and washer. Tighten securely.

7.Reposition the stove so the first rear leg can be at- tached. Attach the leg using the procedure described in Step 6. (Fig. 21)

8.Reposition the stove so the remaining leg can be attached. Attach it using the procedure described in Step 6. Remove the pallet from beneath the stove.

9.Remove the (4) 1/4-20 x 3/8” hex head bolts from the mounting bosses and attach the bottom heat shield using the same bolts.

Carefully move the stove to its final position. One way to lessen the effort of moving the stove over smooth flooring is to slide it on a piece of inverted carpet. Move it slowly to ensure the floor is not scratched.

Retighten all leg fastening hardware.

	ST816
Fig. 21	Reposition stove so one rear leg can be attached.

Dutchwest Non-Catalytic Convection Heater

Fan Kit Installation

1.Secure the fan assembly to the inner back with two

(2) 1/4-20 x 3/4” hex head screws and one (1) 1/4” star washer as shown in Figure 22.

2.Attach snapstat to the mounting holes on the un- derside of the bottom with two (2) 1/4-20 pan head screws.

3.Attach the rheostat to the door handle insert holder near the front left leg. Insert the rheostat control shaft through the handle holder hole. Install the retaining ring and rheostat knob onto the shaft.

4.Place cables where they won’t be harmed by traffic.

5.Fan will not operate until stove reaches approxi- mately 109°F.

		Rheostat
		Knob
	Pan	Snapstat
	Head
	Screws
ST813		Rheostat
Fig. 22	Fan installation.

30002291 17