Insignia NS-LCD26F/NS-LCD32F/NS-CL26C LCD TV
Item Description
30
NEXT button. Press to go to the next chapter or track. Press again to skip forward by chapter or track.
31
PREV button. Press to go to the previous chapter or track. Press again to skip back by chapter or track.
32
STOP button. Press to stop DVD and CD playback.
33
PAUSE/STEP button. Press to pause DVD playback. Press again to step through a DVD one frame at a time.
34SLOW button. Press to decrease the DVD playback speed.
Note
Objects between the remote control and the sensor may weaken the remote control’s IR signal.
Range can be diminished by direct sunlight shining on the TV’s IR sensor.
Cautions
Do not expose the remote control to liquids, direct sunlight, or shock.
The remote control may not work correctly if the TV’s IR sensor is under direct sunlight or strong lighting. In these cases, change the angle of the lighting or the TV screen, or operate the remote control closer to the IR sensor.
Setting up your TV
Installing the remote control batteries
To install the batteries:
1Open the battery compartment (1) on the back of the remote control.
123
2Insert the two AA batteries (2)(provided) into the battery compartment. Make sure that the
(+) and
3Close the battery compartment (3).
Using the remote control
To use the remote control:
•Point it directly at the TV, within a 30° angle of the IR sensor on the front of the TV, and within 20 feet.
Connecting to video sources
Connecting to an antenna or cable/satellite receiver
To connect an external antenna or cable/ satellite receiver:
1Connect the antenna cable from an antenna or cable/satellite receiver to the antenna input jack on the TV.
2Press the INPUT button to set the TV’s signal input to TV.
Notes
•To improve picture quality in a poor signal area, you can purchase and install a signal amplifier.
•To split the signal from an antenna, you will need a
Connecting to a VCR
To connect your TV to a VCR:
1Turn off the TV and the VCR (or other source).
2Connect an RF cable to the VCR, then to the ANT. jack on the back of the TV.
3Connect RCA audio cables to the VCR’s audio output jacks, then to the AV IN L and R jacks on the back of the TV.
4Turn on the TV and the VCR.
5Press the INPUT button to set the TV’s signal input to TV.
Connecting to a DVD or other video source
To connect your TV to a DVD or other video source:
1Turn off the TV and the DVD (or other source).
7 |