3M 530, 733, 533 manual Kit Contents, Cable Preparations

1.0 Kit Contents

Note: Visually inspect all components. If any component is missing or appears damaged, do not install. Call 3M customer service at 1-800-426-8688 for a replacement product.

1.1	Kit Contents SLiC 530/533/733-2 Port 0.61 Cable
	Entry Bracket 80-6113-2344-7
	A.	Cable Addition Bracket Assembly (1)
	B.	Cap
	C.	Multi-port Grommet (1)
	D.	Hose Clamp (1)
	E.	Pair Saver
	F.	3M™ Scotchlok™ Shield Bond Connector 4460
		with LSM Clamp (2)

BC

AD

H

	G.	10-32 UNF Flange Nut (2)
	H.	Lubricant (1)
	I.	Instruction Manual 78-0013-2695-4 (Not Shown)
1.2	Kit Contents SLiC 530/533/733-2 Port-MSM 0.61
	Cable Entry Bracket 80-6113-8403-5
	A.	Cable Addition Bracket Assembly (1)

A

F, G E

BC

B.	Cap
C.	Multi-port Grommet (1)
D.	Hose Clamp (1)
E.	Pair Saver
F.	3M™ Scotchlok™ Shield Bond Connector 4460
	with LSM Clamp (2)

H

D

E

G.	10-32 UNF Flange Nut (2)
H.	Lubricant (1)
I.	Instruction Manual 78-8128-0289-6 (Not Shown)

2.0Cable Preparations

2.1Per company practice, remove sufficient cable

jacketing to allow for slack storage and splicing needs (approximately 5 feet).

2.2Trim central strength members on both cables approximately 3" (76 mm) from the end of the cable jacket.

Note: When using ribbon fiber cable, leave a minimum of 2" (50 mm) of central tube.

2.3Insert cables into the multi-port grommet so that 1.25" to 1.75" (32–45 mm) of cable jacketing is exposed past the inside edge of the grommet.

Note: A small amount of lubricant provided in the kit may be placed on the leading edge of the cable to ease installation into the grommet.

Note: Place and tighten a cable tie around the grommet or you may also place a couple of wraps of Scotch® Linerless Rubber Splicing Tape 130C around cable to provide a better seal.

Note: Carefully follow safety, health and environmental information given on product label or the Materials Safety Data Sheet for the lubricant.

F, G

1.25"–1.75"	3" (76 mm)
(32–45 mm)

2 78-8135-7466-8-B