3.0Cable Addition Bracket Assembly Installation
3.1Remove screw on the 3M™ Scotchlok™ Shield Bond
Connector 4464 and swing the plate to the side. If the shield connector is installed with rivets, do not perform this step.
3.2Remove central strength member retainer. Unscrew and remove the central strength member retainer that is intended for use. If installed using rivets, do not perform this step.
3.3Loosen the second screw just enough to allow the cable addition bracket to slide under the CSM retainer. Replace the screw that was removed previously and tighten the shield bond connector tightening fastener between 25 to 30
(2.9 to 3.5
3 |