Receiver Operations
Initial Settings
From the manufacturing facility, the receiver is configured as follows:
Line Locate Frequencies | Selection | Default |
8 kHz | Always Enabled | Enabled |
82 kHz | Always Enabled | Enabled |
Power | Always Enabled | Enabled |
Radio | Enable/Disable | Disabled |
CATV | Enable/Disable | Disabled |
CPS | Enable/Disable | Disabled |
Sonde Locate Frequencies |
|
|
512 Hz | Enable/Disable | Enabled |
640 Hz | Enable/Disable | Disabled |
33 kHz | Enable/Disable | Enabled |
Units | inch or cm | Inch |
Power Frequency | 50 Hz or 60 Hz | 60 Hz |
Contrast | Up or Down | Middle |
Depth Measurement | Live or |
The setup function will allow you to enable or disable additional locating and sonde frequencies.
Receiver Setup
Any of the available frequencies of the 3M™ Dynatel™ Advanced Pipe/Cable Locator 2220M can be activated or deactivated. When a frequency is activated, a check mark will appear beside the frequency in the middle of the setup screen. All frequencies that are activated in the setup menu, will be available in the locate screens.
When the Setup key is pressed, the receiver will cycle through the following screens.
Select the left/right arrow keys (← →) to cycle through the setup screens.
Contrast Adjust
Press the up or down arrows ( or ) to adjust the screen contrast.