Dish Network VIP612 Setting Up Using Device Code Tables, Instructions Additional Information

Remote Control Setup

Operating Other Devices

Setting Up Using Device Code Tables

Set up the remote to control other devices using the device codes listed on page 112. In the instructions below, the column on the left contains the instructions and the column on the right provides additional information.

Instructions	Additional Information
1 Turn the device on.	Use the device’s front panel buttons or its
	remote control.

2Find the brand name of the device in the tables starting on page 112.

3Press and hold the mode button until all the other mode buttons light up, and then let go of the button. The mode button flashes.

If the brand isn’t listed, see Setting Up Using Device Codes Scan on page 68.

For example, hold TV for a TV until all of the other mode buttons light. When you let go, TV will flash.

4For AUX mode only. Press 0 for a TV, or 1 for a VCR, or 2 for a tuner, or amplifier.

5Enter one of the three-digit device codes from the table using the number buttons.

6If you want to program Limited Mode, press 1. If not, skip to step 7.

If you’re not programming in AUX mode, skip to step 5.

The three-digit device code should be for the brand name of your device that you found in step 2.

See Limited Mode for more information.

7Press POUND (#).

8Press POWER to turn off the device. If the device does not turn off, go to step 10.

9Turn the device back on and try some other buttons to make sure they work. If the code works for other buttons, stop here.

If you entered the code correctly, the mode button flashes three times.

If the code works, the device should turn off.

Sometimes POWER works when other buttons don’t. If in Limited Mode, try VOLUME or MUTE.

67