Humax IR-ACE II, IR-FREE, IR-TWIN manual $ 30/ 732 /8

Page 28

$￿ ￿￿￿￿5￿￿￿ ￿)￿￿￿￿

$￿ ￿￿￿￿5￿￿￿ ￿)￿￿￿￿

In order to maintain proper performance of the product, it is essential to have the most up-to-date software. Visit the Humax website to check the latest news and newly released software versions. – http://www.humaxdigital.com. It is recommended that you periodically check for the availability of software update.

$￿￿ 30/ 732￿￿ ￿￿￿ /￿￿8

OTA, an abbreviation of Over–the-Air, is a standard for the transmission of software through a broadcast system.

OTA is simply an alternative method for downloading software versions. However, the manufacturers reserve the right for deciding the release of the software for their products by beaming the latest software versions over the air via satellite. Note that OTA is only limited to certain geographical regions mainly due to different antennas having different footprints(area where the signal can be received). The software update via satellite will only occur under the following circumstances.

1. The equipment should have appropriate loader software.

Caution:

Please note that if normal loader software is not equipped, the product may not be updated or operate properly after software update.

2.The manufacturer decides to release the software via a designated satellite.

3.The equipment must be tuned properly to the same antenna equivalent to that of the manufacturer.

4.Update software when the signal strength and quality is high. If the weather is not favorable, and the signal strength and quality are not recommendable, perform the software update later.

Caution:

Please be careful to keep the power on and the power cord plugged in during software update. If the power is off during software update, fatal damage may be caused to the product.

Please be careful not to pull out the signal line (LNB cable) during software update. Update may be interrupted and the product may not operate.

Caution:

It may take 5 ~10 minutes to update software.

Other functions will not activate while software update takes place.

You cannot schedule recording during software update.The installation wizard pops up automatically and assists channel search.

￿￿ ￿!

Image 28
Contents Page Copyright Copyright 2008 Humax Corporation WarrantyTrademarks Meaning of Symbols Instruction about the ‘WEEE’ SymbolCleaning Mains SupplyOverloading LiquidReplacement of Parts LocationLIGHTNING, Storm or not in USE Extraneous ObjectsTo avoid electrical shock To avoid damage of the power cord or plugTo avoid damage of product Page Page Standby LED Standby ButtonVOL Button TV LEDStandby LED Smartcard Slot Slots for Smartcards Standby LED Power Cord LNBLNB OUT Audio L/RSource TV/RADIONUMERIC0-9 Buttons MenuStandby GuideExit ZOOM-BLUEPage ## + You can set the current time All RED Favourite GreenBouquet Yellow Satellite BlueAdd LockSkip DeletePage Style FindSchedule Group# # Time Setting Output SettingUHF Tuning OSD LanguageOrganising TV/Radio ChannelsOrganising All MoveRename Organising TV/Radio ChannelsOrganising Favourite Group A~DAntenna Setting Humax Auto SearchFixed Antenna Motor AntennaSignal Detection Humax SW UpdateIrdeto SW Update Conditional Access$ 30/ 732 /8 Page No picture on TV set Poor picture/sound qualityRemote control does not operate Cannot update new softwareNo or poor sound Cannot make reservationsNo or bad signal Channel isScrambled or not AvailableInput Connector Signal LevelLNB Power & Polarization Input Symbol RatePower Consumption Weight Net Operating TempVideo Audio# 769 /8