Humax IRCI-ACE user manual Motor Limit Setting

Page 21

To initialise satellite position saved at the Motor Antenna, set DiSEqC Command Mode to Installer, set Motor Control to Reset, then press the OK button. You will see a warning message. To continue the procedure, press the OK button.

To set the motor position for each satellite manually, select your desired Satellite Name, set DiSEqC Command Mode to Installer, and then set Movement to one option among East, Stop, or West. The motor starts moving. The level of signal strength and quality bar at the bottom of the screen will indicate the best position of the dish. Set Motor Control to Store when you find the best position, then press the OK button to save the position.

To move the motor to the pre-set position of the satellite, select your desired Satellite Name, set DiSEqC Command Mode to User, set Motor Control to Goto, and set Movement to your desired value. The movement is used to fine-tune the position of the motor. Press the OK button. The motor will move to the position of the selected satellite.

5. Motor Limit Setting

To enter this menu, press the RED button in Satellite Setting menu. You can set the maximum for both East and West to prevent damage to the antenna.

Limit Setting: When Limit setting is set to Enabled, the motor does not move more than the amount of the limit. When Limit setting is set to Disabled, the setting is released.

Movement: You can select one among East, Stop, or West.

Store East Limit: You can save the East Limit.

Store West Limit: You can save the West Limit.

GB 20

Image 21
Contents IRCI-ACE Page Page Setup GB12 Before Using the ProductInstallation GB15 GB5Service List GB25 Package Contents Radio LED Front PanelStandby LED Smart Card SlotRear Panel Inserting Smartcard Conditional AccessInserting Common Interface CAM Remote Controller Freeze RecallStandby GuideConnecting Antenna/TV Connecting Hi-Fi System Powering On Selecting Language Searching ServicesHumax Auto Search Antenna Setting Smatv Manual SearchDiSEqC Command Mode Movement Motor Control Satellite SettingMotor Limit Setting Default Setting Common InterfaceAutomatic Search Programme Information i-plate Viewing ProgrammeChanging Language Adjusts transparency of teletext screenTeletext Current timeSetting Property of Service Switching Services Organising Services Organising Favourite Services Organising Satellites Button Reserve a programme once a week Language Setting System SettingTime Setting Parental ControlV Output Setting UHF TuningOther Setting STB Upgrade Signal DetectionConditional Access STB StatusCalendar BiorhythmGames OTA Over the Air MENU-INSTALLATION-STATUS-STB Upgrade Software Update from PCNo picture LED on the front panel does not lightPoor picture & sound quality No or poor soundRemote controller does not operate Watching scrambled service is not availableReservation is unavailable Memory Hcsa Humax Customer Service Area HomepageMail Technical Q&A Humax Middle East Call Centre Dubai, UAE Humax Hotline GermanyHumax Btci Hotline Premiere Model