Humax HDCI-2000 manual Front Panel, P + Button

Page 9

1. Before Using the Product

1.2 Front Panel

1.STANDBY BUTTON

Switches between operation and standby modes.

2.TV/RADIO BUTTON

Switches between TV and radio modes.

3.P-/P + BUTTON

Moves the TV/radio channel up or down.

4.VOL-/VOL+ BUTTON

Adjusts the audio volume.

5.VIDEO FORMAT

Changes the resolution of video.

6.CI-MODULE SLOT

A slot for two CI modules

GB 8

Image 9

Contents Page Copyright Copyright 2007 Humax Corporation Meaning of Symbols Safety Instructions and Precautions Safety and WarningTo avoid damage of the power cord or plug Replacement of PartsLIGHTNING, STORM, or not in USE To avoid electrical shock Contents Software Update InstallationMenu Map Trouble Shooting Specification Glossary Service and SupportPackage Contents Before Using the ProductP + Button Front PanelInserting a CI with Smartcard Conditional AccessRS-232C Rear PanelRemote Control 16.OK 17.V- / V+Information Using Hdmi Connector SetupWhen equipped with an A/V receiver Using DVI ConnectorWhen there is no A/V receiver available Using Component Cable Using Scart Cable Powering On Installation Wizard LanguageSearch Channel Installation Wizard Time Software UpdateVolume Control Switching ChannelBasic Operation Lip-SyncResolution Option ListAudio Subtitle TeletextGeneral Information Programme Information i- plateDetailed Programme Information All Channel List Channel ListRenaming Channels Deleting ChannelsIncluding Channels in Favourite Group Using Lock/Unlock Configuring MenuFavourite List Scramble List Satellite ListUsing EPG EPGEPG Main Reserving Programmes Channel ListNUMERIC0-9 buttons EPG Table Schedule ListModifying Schedule Deleting Schedule Find ProgrammeNew Reservation Choosing GenreEntering Programme Name Search by TimeSearch by Day of Week Search Result System CI-ModuleSystem Status Picture TV Screen FormatDisplay Format Scart Signal Dolby DigitalAV Control Setting the Startup-Channel Startup-ChannelStartup-Channel Setting Parental ControlCensorship Classification Installation Lock Change PasswordLanguage Setting Menu LanguageSubtitle Display Time Setting Subtitle FontGMT Offset Power Off Power OnAudio Output A/V SettingOther Settings Display TimeOSD Transparency Edit Channels Edit ChannelsMoving Channels Locking/Unlocking ChannelsSelect/Unselect All Channels Selecting a Channel GroupRenaming Favourite Groups Edit Favourite ListMoving Favourite Channels Selecting Favourite GroupsSelecting/Unselecting All Channels Adding/Removing Channels Installation Search ChannelsFixed Antenna LNB Frequency Satellite22KHz Tone DiSEqC InputMotor Type Motor AntennaMy Latitude My LongitudeEdit Satellite Data Enable Channel search is available DisableActivate Satellite Satellite LongitudeTransponder Motor Driving Motor SettingContinuous Motor moves continuously Step Time Motor moves during specifiedGo to Stored Position Store Current PositionRecalculate Motor Limit Installer MenuLimit Position Set LimitTransponder Reset PositionFrequency PolarizationSymbol Rate TransmissionModulation Network Search Scrambled TypeChannel Type Search Result Antenna Advanced SearchAudio PID Video PIDSmatv Search Smatv Automatic SearchStart/End Frequency Smatv Manual Search Manual Update Automatic UpdatePolarisation Press the OK or Back button Default SettingOTA Over the Air Software UpdateMandatory Update New software is found when powering onMenu Map Trouble Shooting Trouble ShootingNo picture on TV set Poor picture/sound qualityNo password information is given Remote control does not operateCannot update new software No or poor soundError message Possible causes What to do Error MessageTuner & Channel SpecificationAudio/Video/Data In/Out Glossary PID Packet Identifier Qpsk Quaternary Phase Shift KeyingSmartcard Pdif Sony/Philips Digital Interface formatService and Support Sweden Tel Italy TelFinland Tel Opening Hours Austria Tel