Humax NA-3712 manual Reference, Connect DiSEqC, Connect a Satellite antenna

Reference

1. Connect DiSEqC 1.0

All our receivers are designed to be DiSEqC 1.0 compatible. This allows multiple antennas to be connected to the STB simultaneously.

If you have two or more fixed antennas or LNBs, you can use a DiSEqC 1.0 switch.

1.Connect the coaxial cable from the first LNB to the LNB 1 or LNB A input connector of the DiSEqC switch.

2.Connect the coaxial cable from the second LNB to the LNB 2 or LNB B input connector of the DiSEqC switch.

3.Do the same for other LNBs.

4.Connect one end of a Coaxial cable to the RF output connector of the DiSEqC switch and the other end to the LNB IN socket on the STB.

2. Connect DiSEqC 1.2

Please refer to page GB37.

The Locking Time might take longer than expected during the initial boot if the motorised system is set “enable” mode.

3. Connect a Satellite antenna

To the digital receiver, you can connect either a single satellite antenna directly or through converter box several antennas or LNB of multi-feed equipment.

You can connect a further Sat-receiver (for example analog), with the receiver of common antenna equipment that has satellite signals.

GB7