Canon DT 9500 CI user manual Setup, Connecting Antenna/TV/VCR, Using Scart Cable

Page 13

2. Setup

2. Setup

This chapter describes how to set up the product. Select the most appropriate procedure depending on your requirements. Before you connect the product to any other equipment, you must disconnect all equipments from their power sources.

Note: If you encounter any problem when setting up the product, please contact your local product distributor.

2.1 Connecting Antenna/TV/VCR

1. Using SCART Cable

1.Connect the antenna to the LNB IN of the product.

2.The SCART cable is connected as in the figure above.

GB 12

Image 13

Contents Digital Satellite Receiver CryptoWorks Embedded Page Safety Warning Contents Contents Package Contents Before Using the ProductDigiturk CH LED Front PanelRF OUT Rear PanelInserting Smartcard Conditional AccessInserting CI Common Interface Module Guide EPG Remote ControlFreeze Connecting Antenna/TV/VCR SetupUsing Scart Cable Using RCA Cable Using RF Cable Connecting Audio System Powering On Basic Operation Installation WizardBanner Programme Information Viewing ProgrammeSoundtrack SubtitleTeletext Menu Map Menu Map Digiturk Installation InstallationChange CAS Slot of All Digiturk Channels Antenna Setting Advanced InstallationManual Search DiSEqC Command Mode Movement Motor Control Satellite SettingMotor Limit Setting Automatic Search Desired Symbol RateOrganise All Channels Organise ChannelsOrganise Favourite A~B Organise Satellites Factory Settings Language Setting System SettingsTime and Date Setting UHF Tuning A/V Output SettingOther Setting System Information Parental Rating Parental ControlModify PIN code Front Panel LockChannel List Switching ChannelsSetting Property of Channel Favourite List Calendar UtilityBiorhythm GamesProgramme Guide Reserve the programme once a week Mail Conditional Access Common Interface OTA Over the Air Software UpgradeSoftware Upgrade No picture TroubleshootingReservation is unavailable Mpeg Transport Stream A/V Decoding Specification