Canon DT 9500 CI user manual Using RF Cable

Page 15

2. Setup

3. Using RF Cable

1.Connect the antenna to the LNB IN of the product.

2.The RF cable is connected as in the figure above.

Note: The default UHF channel is 36.

GB 14

Image 15

Contents Digital Satellite Receiver CryptoWorks Embedded Page Safety Warning Contents Contents Package Contents Before Using the ProductDigiturk CH LED Front PanelRF OUT Rear PanelInserting Smartcard Conditional AccessInserting CI Common Interface Module Guide EPG Remote ControlFreeze Setup Connecting Antenna/TV/VCRUsing Scart Cable Using RCA Cable Using RF Cable Connecting Audio System Powering On Basic Operation Installation WizardBanner Programme Information Viewing ProgrammeSoundtrack SubtitleTeletext Menu Map Menu Map Installation Digiturk InstallationChange CAS Slot of All Digiturk Channels Antenna Setting Advanced InstallationManual Search DiSEqC Command Mode Movement Motor Control Satellite SettingMotor Limit Setting Automatic Search Desired Symbol RateOrganise All Channels Organise ChannelsOrganise Favourite A~B Organise Satellites Factory Settings System Settings Language SettingTime and Date Setting UHF Tuning A/V Output SettingOther Setting System Information Front Panel Lock Parental ControlParental Rating Modify PIN codeChannel List Switching ChannelsSetting Property of Channel Favourite List Games UtilityCalendar BiorhythmProgramme Guide Reserve the programme once a week Mail Conditional Access Common Interface OTA Over the Air Software UpgradeSoftware Upgrade No picture TroubleshootingReservation is unavailable Mpeg Transport Stream A/V Decoding Specification