Canon DT 9500 CI user manual Satellite Setting, DiSEqC Command Mode Movement Motor Control

5. Installation

3. Satellite Setting

This menu appears only when you enable Motorised System in Antenna Setting menu and press the OK button while Antenna Alternative in Manual Search menu is selected.

•Satellite Name: Select a satellite to identify a motor antenna. If the desired satellite name is not listed, then select "other".

•Movement: In user mode, this is used to fine-tune the position of the motor. In installer mode, this is used to search for the position of the satellite manually.

•Motor Control: You can select one option among "Search", "Go to",

"Store" or "Reset".

**

-Search: Searches for channels on the selected transponder.

-Go to: Moves the motor to the saved position of the selected satellite.

-Store: Saves the current position of the motor for the selected satellite.

-Reset: Resets all saved positions of the motor relative to the 0 position. (Installer Mode Only)

**

•DiSEqC Command Mode: Select "Installer" or "User mode".

The following table shows the value of the motor setting options.

DiSEqC Command Mode	Movement	Motor Control
Installer	East / Stop / West	Search / Go to / Store / Reset
User	Stop(60E) ~Stop(0) ~Stop(60W)	Search / Go to / Store

GB 26