For Use With a Satellite Dish
TV55 Installation Procedure for use with a Satellite Dish
If you have a satellite dish it is possible to install the TV55 using the same wiring as the satellite dish. To do this you will need to purchase a set of diplexers (Terk model BDS-P1). The instructions listed below are for a basic satellite system. If you have a more complex satellite system and wish to install the TV55 in this manor please call TERK Support at 1-800-290-6650.
Note: THE POWER-INJECTOR SHOULD NOT BE INSTALLED WHEN USING A SATELLITE SYSTEM WITH THE TV55.
1.Disconnect the coaxial cable from your satellite dish’s LNB.
2.Reconnect this coaxial cable to the outdoor diplexer on the terminal labeled “SAT/ANT”.
3.Connect the RG6 coaxial cable downlead from the TV55’s “F”- connector to an OUTDOOR diplexer-port (not included) labeled “ANT”. Connect the remaining coaxial cable from the LNB to the diplexer-port labeled “SAT”. (The ports on all of the diplexers are “F”-connectors.)
4.Disconnect the coaxial cable from your Satellite Receivers "SAT-IN" Terminal and reconnect it to an Indoor Diplexer (not included) "TV/SAT"
5.Connect an RG6 coaxial cable from the INDOOR diplexer-port labeled “SAT” to the “F”-connector port on the back of the satellite receiver labeled “SAT-IN”. Connect an RG6 coaxial cable from the INDOOR diplexer-port labeled “TV” to the “F”- connector port on the back of the satellite receiver labeled “ANT IN”.
6.Connect an RG6 coaxial cable from the satellite receiver port labeled OUT-TO-TV to the “F”-connector port at the back of the “TV” labeled “ANT-IN”.
Note: For assistance locating any antenna accessories not included with this product please call our Technical Support Department toll-free at 1-800-290-6650 Monday through Friday 9:00AM to 5:00 PM EST or contact us at www.audiovox.com.
