Kathrein UFS 640si manual Satellite, Channel Search Mode

SEARCH CHANNELS (CHANNEL SEARCH)

Satellite

Using the buttons, select the satellite to be scanned. Make sure your reception system is aligned to the selected satellite. You can search only one satellite at a time. If you have connected a multi-feed reception system (e.g. reception of ASTRA 19.2° East and HOTBIRD 13° East), you must repeat this procedure once for each satellite. You can however start the first installation again, in the course of which a channel search of all the satellites you selected is performed.

Press the button to move to the next selection item.

Channel Search Mode

Use the buttons to select whether you wish to search “free & encrypted” or “only free” channels.

Press the button to move to the next selection item.

Network Search

Use the  buttons (On/Off) to select whether a network scan should be performed. If you set the network search to “Off”, only the factory stored transponders of the satellites you previously selected will be searched for new as yet unlisted channels.

If you set the network scan to “On”, the transponder network enables additional transponders that have not yet been stored to be located. They are then stored and searched for new channels in the same way as the existing transponders.

When you have made your settings, use the  buttons to select “Start Search” and press the 

button to start scanning. You can cancel the scan at any time by pressing the button. During the search you will see the following message (example):

Radio

channels found

TV channels

found

Satellite with the

transponder

currently being

searched

Progression bar

51