MODEL UA845 ANTENNA DISTRIBUTION SYSTEM
The Shure Model UA845 is an amplified, UHF Antenna Distribu- tion System that expands a wireless microphone system by splitting one pair of antennas to multiple Shure UR4 wireless receivers. It also amplifies RF signals to compensate for insertion loss due to splitting signal power to mulitple output connectors. Each UA845 al- lows up to four receivers to use the same antennas. CASCADE connectors allows connections to a fifth receiver or a second UA845. There are also power connectors for powering Shure UHF Wireless systems.
Each system contains the following items:
•UA845 Antenna Distribution System
•
•
•
•
•Power Cord
•Antenna cables for receiver connections
To get the most from this system, follow these guidelines:
•When using long runs of cable for
•Locate multiple transmitters more than 3 m [10 ft] from receiving antennas
CONTROLS AND CONNECTORS
SYSTEM FEATURES
•Expandability. The UA845 UHF Antenna Distribution System is designed for large UHF wireless systems. Each unit allows up to four wireless receivers to use the same two antennas, and the CASCADE ports allow connection to a fifth receiver or a second UA845.
•Compatibility. The UA845 is compatible with all Shure wire- less microphone receivers operating within a compatible fre- quency range (see UHF Carrier Frequency Ranges in the Specifications section).
•CASCADE Ports. Two 50 Ω,
•Power OUTPUT and OUT Connectors. Up to five (5) UR4 receivers can be
•Low Noise and Intermodulation Distortion. The UA845 maintains clean signals with minimal distortion.
•Insertion Loss Compensation. Whenever a signal is split to multiple output ports, there is a loss in signal strength. The UA845 amplifies signals to compensate, ensuring a strong sig- nal to the receivers.
•
Front Panel
UA845
UHF ANTENNA DISTRIBUTION SYSTEM
POWER INDICATOR | POWER ON/OFF |
| |
| SWITCH |
Back Panel
1 | 2 | 3 | 4 | 5 | 3 | 4 | 5 |
1AC Power INPUT Connector.
2AC Power OUTPUT Connector. Each UA845 has a Power OUTPUT connector for
(5)Shure Model UR4 UHF Diversity Single or Dual Receivers to a single power source.
NOTE: This connector does not work for Shure ULX4 Receivers.
3ANTENNA IN Ports, Channel A & B.
4RF CASCADE Connectors (Output connector 5), Channel A & B.
5RF OUTPUT Connectors, Channel A & B.
ENGLISH | 3 |