C:\> ftp 172.22.117.70
User (172.22.117.70:(none)): root 331 Password required for root. Password: admin
230 User root logged in ftp> bin
200 Type set to I. ftp> cd wfs/mpg
250 CWD command successful. ftp> put vbs1d1.sdp
200 PORT command successful.
150 Opening BINARY mode data connection for vbs1d1.sdp
226 Transfer complete.
ftp: 739 bytes sent in 0.12 Seconds ftp> bye
Local UI Location
Local UI Location
When the start mode is configured for Local, the STB will allow static listings and previews of multiple channels on the network. You can use this setting to create a custom user interface.
When the Start Mode is configured for Local, the STB will display static listings and previews of multiple channels on the network. These listing are configured in an xml file. The xml file must be modified for each network installation so that IP addresses, port numbers, encoder types and program listings correspond to actual network settings. This file is edited for local mode installations only and does not apply when operating in MCS or
Home Page Location/Home Page Enable
Home Page Location/Enable
This parameter determines the location of the home page that is displayed when the WWW button is pressed on the IR remote control. When this option is disabled, the Home page will not be loaded when the WWW button is selected.
Main Volume/Line 1 Volume
In MCS mode, when the volume has been manually turned down using the remote (and the configured audio level is significantly higher), there will be a brief burst of higher volume when switching views between preview and full screen. Reduce the configured audio level to avoid abrupt changes in volume.
Main and Line 1 Volume
These parameters determine the initial volume level the STB will provide to the TV or monitor. Set both to same value. The volume can be changed using the IR remote control but will revert to the configured values at
12 | EtherneTV Media Distribution System |