Adjusting the picture, TV mode | Technicolor

42pb120S4-en 2/07/04 11:32 Page 14

Adjusting the picture

PICTURE menu in TV mode

	PICTURE
	Return
EN	Return
	Brightness
	Brightness
14	Contrast
14	Contrast
	Colour
	Sharpness
	Tint
	Tone	Cold
	Auto format	Low
	Noise reduction	Low

Display the OVERVIEW menu using the MENU button. Select Picture and press OK to confirm.The PICTURE menu appears.

The contents of this menu depends on the signal.

In TV mode:

Adjust the Brightness, Contrast, Colour and Sharpness settings as required.

The Tint option is only available when a NTSC signal is detected. It is used for adjusting the picture’s tint.

To adjust the colour temperature, select the Tone option and select a

setting using the buttons.

Check the box for the Auto format option so that the appropriate format is automatically applied to the picture.

Note: if you are watching an AV programme through AV3 or Component Y/CB/CR, this function is not available.

PICTURE menu in PC mode

PICTURE

Return

Brightness

Contrast

ToneNeutral

V-Size

V-Position

H-Size

H-Position

Phase

Use the Noise reduction function to improve the quality of the

picture in the case of poor reception. Use the buttons to select one of the options.

In PC mode:

Adjust the Brightness and Contrast settings as required.

To adjust the colour temperature, select the Tone option and select a

setting using the buttons.

Use the V-Sizeoption to change the vertical size of the picture. Using

the buttons, move the cursor to the right to enlarge the picture, or to the left to reduce it.

Use the V-positionto move the picture vertically. Using the

buttons, move the cursor to the right to shift the picture up, or to the left to shift it down.

Use the H-Sizeoption to change the horizontal size of the picture.

Using the buttons, move the cursor to the right to enlarge the picture, or to the left to reduce it.

Use the H-positionto move the picture horizontally. Using the buttons, move the cursor to the right to shift the picture to the right, or to the left to shift it to the left.

The Phase option allows you to finetune the set in order to perfectly synchronize it with the video signal source.

Press the EXIT button to close the menu. Select Return to return to the OVERVIEW menu.