Using the remote control for other equipment
The remote control supplied with your set can be used for other equipment, such as video recorders, PC or DVD players. This page provides information concerning the remote control’s use with these types of equipment.
|
|
|
|
| VCR | DVD |
VCR |
| Press the VCR button |
| |||
DVD |
|
| Press the DVD button | |||
|
|
|
|
| On/Standby | On/Standby |
|
|
|
| |||
MENU |
| To display the main menu | To display the main menu | |||
|
|
|
|
| Vertical scrolling in menus | Vertical scrolling in menus |
|
|
|
|
| Horizontal scrolling in menus | Horizontal scrolling in menus |
OK |
| To confirm an action | To confirm an action | |||
|
|
| ||||
EXIT |
| To close a menu | To close a menu | |||
|
| To directly access channels or enter | To enter numeric values or select options | |||
|
|
|
|
| numeric values | in menus |
PR+/PR- |
| To change channels |
| |||
AV |
| To select AV input | To select | |||
REV |
| Rewind | Rewind | |||
PLAY |
| Play | Play | |||
FWD |
| Fast forward | Fast forward | |||
STOP |
| Stop | Stop | |||
PAUSE |
| Pause picture | Pause picture | |||
REC |
| Record |
|
Programming the remote control
Automatic code search
This method can be used to automatically find the most appropriate code protocol for your appliance.
1.Switch on the appliance you wish to use the remote control with.
2.Press the relevant button for this appliance on the remote control, and while holding this button down, press
the |
| standby button until the remote control light comes on. Release the two buttons. |
|
3.Point the remote control at the appliance and press PLAY. Wait until the light stops flashing. If the appliance has
not gone into standby mode after five seconds, press the PLAY button again to continue the search for the next set of codes.Repeat this operation until the appliance goes into standby mode. There are 20 sets of codes.
4.When the appliance goes into standby mode, press the standbybutton on the right up side to switch it on
again. Then press the REV button to put it back in standby mode, and if necessary, keep pressing until the appliance goes into standby.
5.Press the STOP button and hold it down until the remote control light goes off. Note: you can cancel the programming operation at any time by pressing the EXIT button.
Manual programming
This method involves carrying out a manual search for the code to be used for controlling your other appliances.
1.Switch on the appliance you wish to use the remote control with.
2.Press the relevant button for this appliance on the remote control, and while holding this button down, enter one of the codes relevant to your make of appliance (there is a list of codes at the end of this manual). If the remote control light flashes you have entered the wrong code or it is not possible to program the remote control.
3.Point the remote control at the appliance and press the relevant button (VCR or DVD). Press thestandby
button. If the appliance does not go into standby mode, try another code.
Depending on the year of manufacture and the type of appliance, some functions may not be available.
Certain codes may cover more functions than others. Test the functions you can control and, if appropriate, try other codes.
Note here the code(s) which work best.
VCR DVD
When you change the remote control’s batteries, remember to reprogram it.
10