Getting Started, Switching on | Technicolor

3. GETTING STARTED

Switching on

Follow the instructions on this page on how to switch on your TV set and the remote control before going on to following pages describing how to use the remote control and the channel set-up procedure.

1. Connect the female plug to AC power input of the set.

2. Connect the male plug to the wall outlet as illustrated.

Equipment for the UK is supplied with a mains cable fitted with a moulded plug.

This plug contains safety components and must not be replaced by one sold by general retailers. It is fitted with a fuse that

protects your television.

If your set has stopped working, the fuse may have blown. If it has, replace it with an identical ASTA or BSI certified (BS1362)

5-amp fuse.

3.Connect the outside aerial or cable network to the socket at the back of the TV set.

The aerial socket (75 Ohms - VHF / UHF / cable) can be used

for connecting an external aerial or other equipment fitted with a modulator (video recorder, satellite receiver, etc.).

We recommend that you do not connect other equipment (video recorder, satellite receiver, etc.) to your TV set to begin with, so

as not to complicate the set-up procedure with the additional steps involved. Connect them when you have finished setting up the channels by referring to page 21 of this manual.

4.Switch the TV on by pressing the on/off button on the right side.

You will find a description of how to use the remote control on

page 9. Then go to page 11 for information on the initial set-up, or to page13 for information on manual set-up (if the channels

have already been set up on your TV).