Chief Manufacturing MSS6000 installation instructions Removing Display from Mount

Installation Instructions					MSS6000
			1	Remove bolt
				or padlock	2
				if used
	May remove
	pin and nut and	1
	move to lower holes
			Pin in
		2	"Closed"
			position -
			move to
			"Open"
			position to
			remove
			display
		A padlock or bolt
		may be placed
		through latch holes		4
		Figure 7
Removing Display from Mount
1. Remove bolt or padlock from faceplate (if used).
	(See Figure 8)
NOTE: The pin may have been used as a more permanent
	locking device. If so, remove nut and pin and move
	from the lower holes to the upper holes.		Pin in
2.	Pull back on flag on upper mounting hole and press pin		"Open"
			position -
	down into "Open" position. (See Figure 8)
			move to
3.	Carefully lift display from mount.
			"Closed"
4.	Lift up on pin and place flag back against faceplate to return		position
			after display
	it to "Closed" position. (See Figure 8)
			is removed.

Figure 8

7