Bell'O 8160, 8165 manual Adjusting your mount

Page 18

Adjusting your mount

After your TV is installed, you can adjust the tilt and horizontal position. The tilt knob carries the weight of the TV and must be tightened with the supplied Allen Key Tool (Y) after the desired position of the monitor is achieved. Tighten the tilt knob until the TV is firmly locked in position. Refer again to Figure 11 for information on locating each of these knobs.

Do not loosen the screw on the opposite side (see Figure 15) because it holds the tilt assembly together.

Figure 15

Figure 16

DO NOT

ADJUST KNOB

FROM THIS

LOOSEN

SIDE ONLY

SCREW

 

If you plan to adjust the position of your TV regularly, you can tighten the horizontal pan knob by hand (see Figure 16). To keep it in a permanently locked position, however, you need to tighten it with the supplied Allen key. Under no circumstances should you completely loosen and/or remove any of these knobs.

English

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Page Introduction About This Manual Icons Used in This BookFoolish Assumptions Precautions Parts Included in This Kit Tools You Will Need #14 X 64mm Lag Bolt, Quantity Allen Key Tool, QuantityAttaching the Monitor Plate Getting ready to hang the TVWho is VESA? Choosing which screws to useOr E Securing the Monitor Plate Holder Finding a wood stud to mount toDetermining the location of the TV Using the Installation Template CheckWhen mounting to a wood stud Supporting Stud WallWhen mounting to solid concrete or cinder block Concrete Block Wall76mm minimum hole depth Don’t forget those wires Mounting the TVGetting the mount ready for attaching your TV Mounting the TV View from Rear of TVUsing the wire management feature Adjusting your mount Storing the Allen Key Tool If you need to remove the TVLimited Lifetime Warranty Bell’O International Corporation
Top Page Image Contents