Bell'O 8160, 8165 manual Mounting the TV, View from Rear of TV

Page 16

Mounting the TV

When you’re ready to put the Monitor Plate (MP) onto the Extension Arm (EA), get a friend or an assistant to help you lift the TV and guide the monitor plate onto the extension arm as shown in Figure 12.

After you’re confident that the TV with the Monitor Plate (MP) is properly seated into the Extension Arm (EA), you need to tighten the Security Screws (SS) using a Phillips-head screwdriver as shown in Figure 13. Because your TV is already attached to the extension arm, you need to work from above and behind the monitor to do this.

Figure 13

(View from Rear of TV)

Figure 12

MP

EA

SS

EA

After the TV is installed, carefully try to lift it off to make sure it is secure.

If it has been correctly installed, the TV should not move.

English

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Page About This Manual Icons Used in This Book IntroductionFoolish Assumptions Precautions Parts Included in This Kit Tools You Will Need #14 X 64mm Lag Bolt, Quantity Allen Key Tool, QuantityAttaching the Monitor Plate Getting ready to hang the TVWho is VESA? Choosing which screws to useOr E Securing the Monitor Plate Holder Finding a wood stud to mount toDetermining the location of the TV Using the Installation Template CheckWhen mounting to a wood stud Supporting Stud WallWhen mounting to solid concrete or cinder block Concrete Block Wall76mm minimum hole depth Mounting the TV Don’t forget those wiresGetting the mount ready for attaching your TV Mounting the TV View from Rear of TVUsing the wire management feature Adjusting your mount Storing the Allen Key Tool If you need to remove the TVLimited Lifetime Warranty Bell’O International Corporation
Top Page Image Contents