Bosch Appliances LTC 9349MK instruction manual Installation, Photo 2 Ceiling Mounting Top View

LTC9349MK Instruction Manual Installation EN 3

3INSTALLATION

Backbox Module Mounting in Suspended Ceiling

Mount the backbox in a suspended ceiling grid using the existing ceiling tile, as follows.

1.Locate the bracket assembly at the desired location (PHOTO 2). Loosen the securing screws on the base bracket assembly (PHOTO 4) enough to retain the suspension bars during handling, but allowing adjustment during installation.

3.Tighten the 4 bracket screws located in each corner (PHOTO 4).

x 4

Ceiling Tile

Suspension

Bars

Ceiling Base

Bracket

Photo 2: Ceiling Mounting (Top View)

2.Snap the bar clips over the ceiling rails (PHOTO 3). Slide the base plate to the desired position on top of the tile.

x 4

Photo 3: Bracket Clip Fitting

Photo 4: Bracket Securing Screws

4.Secure the bracket assembly to an overhead securing point using a safety cable (PHOTO 5).

Photo 5: Safety Cable Fitment

5.Cut a 172 mm (6.75-inch) diameter hole in the center of the mounting plate using two (2) pencils (or a pencil and nail) and the template tool (provided with the LTC 9349 Unity Dome Series).

6.Install the unit as instructed in the LTC 9349 Unity Dome Series manual.

Bosch Security Systems 21 July 2003