Acu-Rite 150 manual Mounting Requirements Senc, End hole mounting, With center support

Mounting Requirements										SENC 150
Mounting options can be adapted to machine mounting surfaces					Center support		1/4-20 x 3/4” SHCS
using spacers, standoffs, or leveling set screws.
• Measuring length and mechanical configuration of your						Support washer
	machine determine your options.										Scale
• Backup spar mounting is an option but not required for lengths		.94 [23.8]
	up to 60”.									washer
• Fastener lengths described on this page are included with the
	encoder or the backup spar.
				End hole mounting				1/4-20 x 1” BHCS
				with center support				Typical (supplied)
			• 24” to 60” : Use end mounting holes with center support.
End hole mounting				Backup spar mounting				M4 x 8mm SHSS
									(supplied)

1/4-20 x 1” BHCS
& scale washer (supplied)
	1/4-20 x 1/2” BHCS
	& spar washer (supplied)
• Less than 24” : Use end mounting holes.	• Over 60” : A backup spar is required.
ACU-RITE®	8

516291-21_Ve00_SENC_150.indd 10

10/22/2009 10:00:42 AM